Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

Investigation and Comparison of AC Losses on Stabilizer-Free and Copper Stabilizer HTS Tapes

Power Dissipation in the HTS Coated Conductor Tapes and Coils under the Action of Different Oscillating Currents and Fields

AC Losses Analysis of HTS Composite Conductors with Different Current Ramp Rates

Power Dissipation in HTS Coated Conductor Coils under the Simultaneous Action of AC and DC Currents and Fields

Experimental Study on AC Loss of 1G and 2G HTS Coils with an Identical Structure, Geometry and Number of Turns

Simulation of Current Profile and AC Loss of HTS Winding Wound by Parallel-Connected Tapes

Transport Ac Losses of a Second-Generation HTS Tape with a Ferromagnetic Substrate and Conducting Stabilizer

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Experimental Evaluation of Ac Losses in the Cold Dielectric High-Temperature Superconducting Cable

AC Loss Study in REBCO HTS Tape and Four-Tape Stack Carrying AC Current with DC Offset

AC Loss of Stacked HTS Tapes Subjected to a Rotating Magnetic Field

AC Losses in Horizontally Parallel HTS Tapes for Possible Wireless Power Transfer Applications

Electromagnetic characteristics analysis of High Temperature Superconductor stack with magnetic substrate

Transport Current Losses in Bi2223 High Temperature Superconductors

Ac Loss Characteristics of A Cylindrical High Temperature Superconductor

Investigation of AC Loss in HTS Cross-Conductor Cables for Electrical Power Transmission

Study on the Influence of Skin Effect on AC Loss of YBCO Tape

AC Loss in High-Temperature Superconducting Bulks Subjected to Alternating and Rotating Magnetic Fields

Measurement and Numerical Calculation of AC Losses in Second-Generation High Temperature Superconductor Current Leads

Modelling Analysis of Periodically Arranged High-Temperature Superconducting Tapes

A Study on AC Losses of HTS Pentagonal Conductors Consisting of 2G Wires Carrying DC Offset Transport Current