Abstract:The strength of prestressed steel strands has developed towards high strength, increasing from 1860 MPa to over 2200 MPa. The stress in the prestressed anchorage zone is more concentrated and complex, and the anchor plates for dispersed loads need to be optimized in design. This article proposes a design scheme for adding a middle pressure-bearing step based on the existing anchor plate and then establishes a 1/4 model of the concrete anchoring area of the anchor plate for finite element analysis. Based on the theory of the strut-and-tie model, the position of the middle pressure-bearing step is determined according to the maximum angle of the strut-and-tie model. Then, carry out force transfer tests in the anchorage zone for verification. The research results indicate that after adding a middle pressure bearing step to the anchor plate, the angle between the strut-and-tie model in the anchorage zone increases, and the bearing capacity improves. The position of the middle pressure-bearing step in the anchor plate is different, and the angle between the strut-and-tie models is different. According to the middle step position parameter, λ (the ratio of the effective width of the middle step to the distance from the middle step to the end face of the anchor plate) is 0.533 to optimize the anchor plate, and the bearing capacity of its anchorage zone is relatively high. The main tensile and main compressive stresses of the anchor plate after optimization increased by 6.2% and 5.74%, respectively, compared to the anchor plate before optimization. The main tensile stress of the spiral reinforcement under the anchor plate decreased by 0.59%, the main compressive stress decreased by 2.89%, and the von-Mises stress decreased by 2.32%. The side surface tensile stress of concrete under the anchor plate was reduced by 4.3 percent. Finally, three concrete specimens were poured for force transfer testing in the anchorage zone, verifying the safety and reliability of the optimized anchor plate in the 2200 MPa-level prestressed anchorage zone.

Elastic-to-Plastic Strut-and-Tie Model for Concentric Anchorage Zones

Strut-And-Tie Model Research On Bridge Column-Pile-Footing

Improved Method of Giuffre-Menegotto-Pinto Hysteretic Constitutive Model

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

Elastic And Elastic-Plastic Stability Of Dual Structural Systems

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Application of Smeared Cracking and Damaged Plasticity Models in FEA of CFT

Systematic Monitoring of the Performance of Anchor Systems in Fractured Rock Masses

Load‐path analysis of transverse tensile stresses in multiple‐pile caps

Stress–Strain Model of High-Strength Concrete Confined by Lateral Ties under Axial Compression

Optimized Design of Anchor Plates for 2200 MPa-Class Prestressing Anchorage Zones

Anchoring Effect of Oblique Crack under Axial Tension Load

Constitutive Model for Full-Range Elasto-Plastic Behavior of Structural Steels with Yield Plateau: Formulation and Implementation

An elastoplastic damage model of concrete under cyclic loading and its numerical implementation

Optimum Strut-and-Tie Models for Reinforced Concrete Beams

Flexural modeling of reinforced concrete elements in usage of anchored FRP systems

A Constitutive Model of Expansive Concrete and Steel Fiber-Reinforced Expansive Concrete under Tri-axial Compression

Three-dimensional finite element analyses for cyclic responses of precast segmental bridge piers accounting for bond-slip degradation

A Damage Model of Concrete including Hysteretic Effect under Cyclic Loading

A Simplified Model and Experimental Response of Self-Centring Bridge Piers with Ductile Connections