Abstract:In order to study the methods of calibrating the accelerometer error model coefficients accurately under linear vibration and high g composite environment,the characteristics of the dual-axis centrifuge are described at first.A dual-axis fixture was designed and fixed on the counter-rotating platform.And the input specific forces of the three axes of the accelerometer were calculated accurately.Then,the static test was performed,in which the spindle axis rotates to equal-spaced angular position and the axis of the counter-rotating platform rotates reversely to corresponding equal position.The average value of the static test was compensated with vibration rectification method.The dynamic test was performed,in which the spindle axis rotates with constant angular rate and the counter-rotating platform axis rotates in the opposite direction with the same angular rate;then the accelerometer error model coefficients were identified accurately.The test simulation results show that the influence of the centrifuge error on calibration accuracy is suppressed greatly using this test method;and the influence of static and dynamic misalignment angles of the counter-rotating platform on the calibration accuracy is quite large and can not be ignored.The measurement accuracy of the centrifuge static and dynamic misalignment angles should be improved and compensated.

Study On Calibration Algorithms Of Gyroscopic Drift Error That Affected By The Acceleration Harmonic Errors Of Vibration Table

Nonlinear Least-Square Iteration For Calibrating Gyroscopic Drift Error Coefficients Based On Vibration Table

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

An Investigation on the Second-Order Drift Error Coefficient Calibration of Gyroscope by Vibration Table

Study on Calibration Method and System Error Compensation of Balancing Machines

Calibration of Gyro Error Model Coefficients on Precision Centrifuge with Counter-Rotating Platform

Calibration method of strapdown inertial measurement unit based on two-axis turntable

Acceleration Harmonic Estimation for Hydraulic Servo Shaking Table Based on Multi-Innovation Stochastic Gradient Algorithm

Impacts of Installation Errors on the Calibration Accuracy of Gyro Accelerometer Tested on Centrifuge

Influence of Rotary Errors of Centrifuge Spindle on Accelerometer Input Accuracy

AN ESTIMATION OF THE MEMS GYROSCOPE ERROR BASED ON THE KALMAN FILTER ALGORITHM

Calibration of Cross Quadratic Term of Gyro Accelerometer on Centrifuge and Error Analysis

Calibration Accuracy of Error Model Coefficients K2 and K3 of Gyro Accelerometer Influenced by Errors of Centrifuge

Impacts of centrifuge errors on calibration accuracy of error model coefficients of gyro accelerometer

The influence of alignment errors on the output accuracy of hemispherical resonator gyro

Error Model Coefficients Calibration Method Of Four Equal-Spaced Installed Accelerometer

Calibration Method of Accelerometer's High-Order Error Model Coefficients on Precision Centrifuge.

Precision tilting platform used for static calibration of accelerometers

Angular Velocity Test Plan Design for Identifying the Error Model Coefficients of Gyro Using Three-Axis Turntable

Identification method of accelerometer nonlinear error model coefficients with vibration rectification