Abstract:Optoelectronic tweezer (OET) has become a powerful and versatile technique for manipulating microparticles and cells using real-time reconfigurable optical patterns. However, detailed research in the dynamics of particles in an OET device is still scarce, and the multiple-particle interactions still need further quantitative investigation. In this study, a dynamics simulation model coupling optically induced dielectrophoretic force, interaction forces between particles, and hydrodynamic and sedimentary forces is established and numerically solved by utilizing a finite element method and a dynamics simulation frame for multi-microparticles’ positioning and assembling in a typical OET device. The spatial distributions of particles in the energized OET device before optically projecting are simulated first and the condition for particle chain formation is discussed. Then, the most representative ring-shaped optical pattern is applied, and the influences of optical-ring tweezer’ dimensions of inner radius R e and width d e on positioning and assembling effect are dynamically simulated and discussed for 5- and 2-μm radius particles. The simulation results indicate the particles inside and outside optical ring both undergo negative DEP and are distributed centre-symmetrically under the action of ring virtual tweezers. Average distance between the particle and center of ring (ADPC) at equilibrium and the system equilibrium time characterizing particle positioning effect dramatically increase for both 5- and 2-μm radius particles while R e increases from 35 to 55 μm. Specially, the captured particles will pile up and immediately form a three-dimensional micropyramid structure when R e approximately equals 25 μm for the 5-μm radius particle. Moreover, ADPC decreases very slowly for both two particle-sizes and the system equilibrium time of 2-μm radius particle vary more obviously than that of 5-μm radius particle with d e increasing from 10 to 30 μm. And the system equilibrium time for 2-μm radius particle is always larger than that for 5-μm radius particle. The primary simulation results are in good agreement with experimental observations; hence this dynamics simulation model can truly predict the particle-moving trajectory and equilibrium positions in an OET device. Moreover, this dynamics simulation holds promise for designing and optimizing optical patterns for accuracy in assembling particles in order to form a specific microstructure.

Research On Higher-Order Dielectrophresis Of Erythrocytes In Optoelectronic Tweezers

Dielectrophoretic behavior of a single cell when manipulated by optoelectronic tweezers: A study based on COMSOL ALE simulations

Research on High-Order Dielectrophoresis for Non-Spherical Cell Using Effective Moment Method

Study on the Assembly and Separation of Biological Cell by Optically Induced Dielectrophoretic Technology

Design and Simulation of Electrodes for 3d Dielectrophoretic Trapping

A Full-Scale Computational Study on the Electrodynamics of a Rigid Particle in an Optically Induced Dielectrophoresis Chip

Escape from an Optoelectronic Tweezer Trap: Experimental Results and Simulations.

The Electrodynamics of Rod‐like Microparticles Based on Optically Induced Dielectrophoresis

Experimental Study on Filtering, Transporting, Concentrating and Focusing of Microparticles Based on Optically Induced Dielectrophoresis

Simulation and Analysis of Particle Trajectory Caused by the Optical-Induced Dielectrophoresis Force

Size-scaling Effects for Microparticles and Cells Manipulated by Optoelectronic Tweezers.

Analysis of the influence of the cell geometry and cell proximity effects on the single-cell trapping using light-induced dielectrophoresis

Hopping mechanism of particles and cells escaping from optoelectronic tweezers traps

Analysis of Influence of Optical Electrode Geometry Effects on Manipulation Using Lateral-Field Optoelectronic Tweezers

Numerical Study of A Dielectrophoresis Separation Device at Multiple Frequencies

Optimizing Optical Dielectrophoretic (ODEP) Performance: Position- and Size-Dependent Droplet Manipulation in an Open-Chamber Oil Medium

Design and simulation of the angle-ended fiber integrated into optoelectronic tweezers chip

Dynamics Simulation of Positioning and Assembling Multi-Microparticles Utilizing Optoelectronic Tweezers

Manipulating and Assembling Metallic Beads with Optoelectronic Tweezers

Comparing ODEP and DEP forces for micro/nano scale manipulation: A theoretical analysis

Influence of Light Pattern Thickness on the Manipulation of Dielectric Microparticles by Optoelectronic Tweezers