Abstract:The surface tension plays a significant role in the hygroscopicity of aerosol particles in nanoscale. However, it cannot be obtained using the existing measurement techniques. In this study, the hygroscopic growth of one single succinic acid (SA) particle is simulated using the molecular dynamic (MD) method. Based on the MD simulation results, the surface tension of the stable SA – water droplet is calculated using a numerical model. Furthermore, the influencing mechanisms of temperature, diameter and concentration of SA on the surface tension of the nanoscale droplet are investigated. Results show that with the temperature increasing from 260 K to 320 K, the surface tension of the droplet decreases, which is mainly caused by the weakening of the intermolecular forces inside the droplet. Besides, the sensitivity of the surface tension to the temperature increases with the increase of the SA concentration, which can be explained by the effect of the temperature and the SA concentration on the radial distribution of SA molecules. With the increase of the particle diameter, the surface tension of droplet first increases and then tends to be constant. The normal components of the Irving-Kirkwood pressure tensors are calculated to explain the effect of diameter and SA on the surface tension. In addition, when the SA concentration is increased, the particle diameter range which has an obvious effect on the surface tension is reduced. Moreover, the surface tension of the nanodroplet is negatively correlated with the SA concentration, and the correlation fits into the logarithmic function form, especially for droplet with a diameter smaller than 6.12 nm. The Szyszkowski equation is employed to fit the relationship between SA concentration and the surface tension of droplet. These findings can provide parameter support for the improvement of theoretical model of particle hygroscopicity and relative kinetic processes. This study highlights further investigation on the surface tension of nanoscale droplet with more complex ingredients.

Experimental Determination and Mathematical Modeling of the Drying Kinetics of A Single Droplet of Colloidal Silica

Modeling and Simulation of the Evaporation and Drying of a Two Component Slurry Droplet

Experimental and Numerical Investigation of Convective Drying of Single Coarse Lignite Particles

Vapour-liquid rebalancing behaviour of free water evaporation kinetics: experimental investigation and modelling

Establishment of Nucleation and Growth Model of Silica Nanostructured Particles and Comparison with Experimental Data

Modeling Simultaneous Heat and Mass Transfer for Microwave Drying on Apple

Molecular dynamics simulations of the evaporation of particle-laden droplets

Pattern formation during the evaporation of a colloidal nanoliter drop: a numerical and experimental study

Numerical and experimental investigation of convective drying in unsaturated porous media with bound water

A thick-layer drying kinetic model and drying characteristics of moisture-containing porous materials

Modelling the primary drying stage of the spray freeze drying process based on the non-equilibrium formulation

Mathematical Models' Establishment of Hot-Air Drying for Spratelloides Gracilis

Mathematical modeling of multi-component aerosol droplet evaporation and growth in indoor environments

Modeling of maltodextrin drying kinetics for use in simulations of spray drying

Self-assembly of colloidal particles from evaporating droplets: role of DLVO interactions and proposition of a phase diagram

Experimental and Theoretical Analysis of the Thermostatic Drying Process in Wetted Porous Sand Beds with Different Pore Sizes

Modeling Solution Drying by Moving a Liquid-Vapor Interface: Method and Applications

Numerical simulation of single lignite particle drying process in high temperature flue gas

Droplets on Micro Structured or Patterned Surfaces with Different Roughness Parameters

Evaporation with the formation of chains of liquid bridges

Molecular dynamics study on the surface tension of nanoscale aerosol droplets consisted of succinic acid and water