Abstract:Previous studies have demonstrated that micro/nanostructured surfaces have great potential for heat transfer enhancement. However, simulating subcooled flow boiling on such surfaces is difficult owing to the lack of proper bubble characteristic parameter models, because most models used in flow boiling simulations were developed based on smooth surface conditions, which may limit their applications in engineering design. In this study, we improved upon one validated bubble characteristic parameter model suitable for subcooled flow boiling on smooth surfaces to adapt to the new hybrid micro/nanostructured surfaces proposed by Huang et al. [“Experimental investigation of a new hybrid structured surface for subcooled flow boiling heat transfer enhancement,” Appl. Therm. Eng. 192, 116929 (2021)]. The new bubble characteristic parameter model incorporates both basic correction terms to account for boiling bubble behaviors and ad hoc parameters to account for other unknown effects. Through sensitivity analysis and detailed calibration, the model was simplified to a set of correlations and only one constant parameter. With this improved model, subcooled flow boiling heat transfer simulations were conducted for three target surface specifications under conditions of 4–10 MW/m2 incident heat flux and 1–5 m/s flow velocity and the related heat-transfer mechanisms were further compared and discussed. The maximum error between the simulation and experimental results remains less than 3.5%, indicating that the established model has considerable accuracy in predicting the heat transfer performance for this type of micro/nanostructured surface in high-heat-flux engineering design applications. The heat transfer enhancement for subcooled flow boiling on this type of hybrid micro/nanostructured surface is greatly beneficial owing to its proper organization of convection, evaporation, and quenching heat transfer.

Modeling of subcooled boiling by extending the RPI wall boiling model to ultra-high pressure conditions

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Multiphase SPH Modeling of Water Boiling on Hydrophilic and Hydrophobic Surfaces

Numerical Simulation of Nucleate Pool Boiling under High Pressure Using an Initial Micro-Layer Thickness Model

A Unifying Bubble-Layer-Based Theoretical Model for Flow Boiling and Application to a Rod Bundle

Development of subcooled wall boiling model considering bubble sliding in narrow rectangular channel

An improved wall boiling model for numerical simulation of subcooled flow boiling on a new hybrid micro/nanostructured surface

A BUBBLE-LAYER-BASED MECHANISTIC MODEL FOR THE SLIGHTLY SUBCOOLED FLOW BOILING IN VERTICAL TUBES

Numerical Study on Bubble Behaviour and Heat Transfer Characteristics of Subcooled Pool Boiling Based on Non-Empirical Boiling and Condensation Model

Study on Local Sub-Cooling Boiling in the Vertical Upward Pipe

Analyses of Bubble Dynamics in Subcooled Boiling Flow Using Euler-Lagrange Method

A modified force balance model for predicting bubble departure diameter and lift-off diameter in subcooled flow boiling

Numerical study of heat transfer and pressure drop characteristics in helical tubes based on OpenFOAM

A Mechanistic Model for Slightly Subcooled Flow Boiling in Vertical Tubes

Numerical Investigation of Flow Boiling Characteristics in Narrow Rectangular Channels Using Two-Fluid Eulerian Cfd Model Covering a Wide Range of Pressures

Interface Tracking Simulation for Subcooled Flow Boiling Using VOSET Method

Investigation of Wall Boiling Closure, Momentum Closure and Population Balance Models for Refrigerant Gas–Liquid Subcooled Boiling Flow in a Vertical Pipe Using a Two-Fluid Eulerian CFD Model

Highly stable subcooled flow boiling enabled by an opposed wall jet design

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Investigation on Sub-models of Population Balance Model for Subcooled Boiling in Vertical Gas-liquid Flow by Comprehensive Evaluation

Evaluation of several liquid–vapor phase change models for numerical simulation of subcooled flow boiling