Abstract:Ultrasonic elliptical vibration-assisted cutting (UEVC) has been successfully applied in the precision and ultra-precision machining of hard and brittle materials due to its advantages of a low cutting force and minimal tool wear. This study developed a novel double-excitation ultrasonic elliptic vibration-assisted cutting (D-UEVC) device by coupling ultrasonic vibrations in orthogonal dual paths. A two-degree-of-freedom vibration system of the D-UEVC was modeled, form which the elliptical trajectory of the end under different phase angle φ values was derived. The initial dimensions of the D-UEVC device were obtained through theoretical calculations. Subsequently, with the aid of finite element analysis methods, structural dynamic analysis of the device was conducted to obtain the elliptical vibration trajectory under different phase differences of the excitation source. In order to verify the cutting trajectory and cutting performance of the D-UEVC device, a prototype of the device was developed, and a series of vibration performance tests as well as the Inconel 718 cutting experiment were conducted. The experimental results illustrated that the D-UEVC device can achieve the elliptical vibration trajectory at the tool tip with a resonant frequency of 36.5 KHz. The adjustable elliptical vibration trajectories covered a range of ±4 μm in the axial and radial directions. Compared with the surface roughness Ra = 0.36 μm under the conventional cutting, the surface roughness of Inconel 718 under D-UEVC was Ra = 0.215 μm. Thus, the surface quality can be significant improved by utilizing the D-UEVC device.

Development of a Novel 2-D Vibration-Assisted Compliant Cutting System for Surface Texturing

An Ultrafast 2-D Non-Resonant Cutting Tool for Texturing Micro-Structured Surfaces

A novel quasi-intermittent vibration assisted swing cutting device: Design and experimental investigation

Generation of Textured Surfaces by Vibration-Assisted Ball-End Milling

Theoretical and Experimental Investigation of Surface Textures in Vibration-Assisted Micro Milling

Preliminary Design of Two Dimensional Vibration Assisted Machining System for Multi-Axis Micro-Milling Application

Development of a novel XZ workpiece vibration generator for cooperative vibration cutting of hierarchical grating structures

Modelling and experimental investigation on textured surface generation in vibration-assisted micro-milling

The Finite Element Analysis and Optimization of an Elliptical Vibration Assisted Cutting Device

Research on a novel non-uniform and asymmetric ultrasonic vibration system

Mechanically Enabled Two-Axis Ultrasonic-Assisted System for Ultra-Precision Machining

Experimental studies of wettability control on cylindrical surfaces by elliptical vibration texturing

Modulated ultrasonic elliptical vibration cutting for ductile-regime texturing of brittle materials with 2-D combined resonant and non-resonant vibrations

Surface texture formation by non-resonant vibration assisted micro milling

Developmental and Experimental Study on a Double-Excitation Ultrasonic Elliptical Vibration-Assisted Cutting Device

Experimental investigation for vibration reduction of surface-textured journal bearings

Surface Texturing of Tribological Interfaces Using the Vibromechanical Texturing Method

Design and implementation of a non-resonant vibration-assisted machining device to create bespoke surface textures

Improving Machined Surface Textures in Avoiding Five-Axis Singularities Considering Tool Orientation Angle Changes

Development of a Force Controlled Nanocutting System Using a Flexible Mechanism for Adaptive Cutting of Microstructures on Non-Planar Surfaces

Generation mechanism of surface micro-texture in axial ultrasonic vibration-assisted milling (AUVAM)