A Facile Spray Pyrolysis Method to Prepare Ti-doped ZnFe2O4 for Boosting Photoelectrochemical Water Splitting

Yongsheng Guo,Ningsi Zhang,Xin Wang,Qinfeng Qian,Shiying Zhang,Zhaosheng Li,Zhigang Zou
DOI: https://doi.org/10.1039/c6ta11134c
IF: 11.9
2017-01-01
Journal of Materials Chemistry A
Abstract:Although spinel zinc ferrite (ZnFe2O4), with a band gap of 1.9 eV, is a promising photoanode material for solar water splitting, its photoelectrochemical performance is usually hindered by poor charge carrier transport. Ti4+ doping was introduced to increase the charge carrier concentration and promote charge carrier transport in the ZnFe2O4 photoanode. Here, pure and Ti4+-doped ZnFe2O4 photoanodes were prepared by a fast and effective spray pyrolysis method. In the Ti-doped ZnFe2O4 photoanode, some of the Fe3+ sites in the crystal lattice are substituted by Ti4+, as shown by powder X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectrometry (FTIR) analyses. The results of Mott-Schottky analysis and electrochemical impedance spectroscopy (EIS) indicated that the substitution of Fe3+ by Ti4+ enhances the charge carrier concentration and electron transfer efficiency. The Ti-doped ZnFe2O4 photoanodes exhibit a solar water-splitting photocurrent of 0.35 mA cm(-2) at 1.23 V vs. RHE (reversible hydrogen electrode), which is 8.75 times higher than that of the pure ZnFe2O4 photoanodes. Hence, this study may provide a simple route to fabricate multi-metal oxide photoelectrodes through ion doping to enhance their photoelectrochemical performances.
What problem does this paper attempt to address?