Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Asymmetric Distribution of Falling Film Solution Flowing on Hydrophilic Horizontal Round Tube

Distribution Characteristics of Falling Film Thickness Around a Horizontal Tube

Numerical simulation of the behavior of falling films on horizontal plain tubes

Hydrodynamic behaviors of the falling film flow on a horizontal tube and construction of new film thickness correlation

The Spatial Distribution of Liquid Film Thickness Outside the Horizontal Falling Film Tube

An experimental and simulation study on the velocity distribution of the falling film on a horizontal tube in jet mode

Numerical Study of Falling Film Flow on a Horizontal Rotating Tube

Liquid film dispersion on horizontal circular tubes under spray impingement

A Comprehensive Numerical Study on the Subcooled Falling Film Heat Transfer on a Horizontal Smooth Tube

Thin liquid film flow and heat transfer under spray impingement

Falling film evaporation in a vertical tube with a new type of liquid distributor designed using the brachistochrone principle

Flow Modes and Mode Transitions for Falling Films on Flat Tubes

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Film thickness distribution in gravity-driven pancake-shaped droplets rising in a Hele-Shaw cell

Analysis on Wave Flow of Laminar-Wavy Falling Liquid Film

Numerical Study of the Surfactant-Covered Falling Film Flowing Down a Flexible Wall

Numerical Simulation of Falling Film Flow in Vertical Channel

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

Modelling of evaporative falling-film heat transfer over a horizontal tube

Thickness Distribution and Fluctuation Characteristics of Liquid Falling Film under Turbulent Conditions

Hydrodynamics and thermal performance of turbulent falling films through horizontal tube bundles