Abstract:Queue length is one of the important indexes to evaluate the operation efficiency of signalized intersection and also the key parameter of intersection signal control optimization. Traditional queue length estimation models are mostly based on fixed detection equipment, and the models assumptions are too harsh; there are certain limitations. Based on the probe vehicle data, this paper establishes a model of queue length estimation for signalized intersection based on shockwave theory. First, based on the speed and location data of the probe vehicle, the vehicle density is calculated to estimate the intersection stop line. A real-time calculation method of vehicle arrival rate is proposed to improve the applicability of the model. Then, based on the shockwave theory, the meeting time of the queue forming wave and the queue discharging wave are calculated after the green light is on. Finally, the queue length is summed in sections, including the distance between the last queued probe vehicle and the stop line during the red light period, the length of the subsequent vehicles arriving during the residual red light time, and the newly increased queue length within the queue discharging time. This paper uses the VISSIM software to simulate the actual intersection. The simulation results show that when the penetration of probe vehicle is 50%, 25%, and 10%, their corresponding mean absolute relative error are 11.27%, 27.77%, and 39.12%, respectively. It can be seen that with the increase of penetration, the error gradually decreases. The average absolute relative error is within the acceptable range. After analyzing the existing similar methods, although the accuracy of the method proposed in this paper does not reach the highest level, it has the advantages of simple operation, less computation, and good real-time computation. Relevant research results can provide support for traffic control at signalized intersections.

Variability of Green Time to Discharge a Specified Number of Queued Vehicles at a Signalized Intersection

Vertical and Horizontal Queue Models for Oversaturated Signal Intersections with Quasi-Real-Time Reconstruction of Deterministic and Shockwave Queueing Profiles Using Limited Mobile Sensing Data

Capacity of unsignalized intersection with mixed distribution headway

Vehicle Queue Length at Signal Controlled Intersection

Model of Start-up Lost Time and Headway of Queuing Motor Vehicles under Mixed Traffic Condition

Minimum Cycle Length of Two-Phase Road Intersection

Influence of Stretching-Segment Storage Length on Urban Traffic Flow in Signalized Intersection

Estimation of Saturation Flow Rate and Start-Up Lost Time for Signal Timing Based on Headway Distribution

Traffic Design and Signal Timing of Staggered Intersections Based on a Sorting Strategy

Estimating Maximum Queue Length for Traffic Lane Groups Using Travel Times from Video-Imaging Data

Queue Length Estimation for Signalized Intersections Using License Plate Recognition Data

A Simple Traffic Signal Control Using Queue Length Information

Queue Length Estimation Based on Probe Vehicle Data at Signalized Intersections

Optimization Method of Signal Timing Parameters Considering Comprehensive Efficiency of All Approach Lanes

Critical traffic volume of traffic signal warrant under limited priority condition

Incorporating Nonuniform Arrivals in Delay Variability Modeling at Signalized Intersections

Modification of Start-wave Model at Signalized Intersection

A Method of Signal Timing Optimization for Spillover Dissipation in Urban Street Networks

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Maximum cycle length optimization method of signalized intersection

Analysis om waiting area for left-turn vehicles at signalized intersections