Abstract:For a future 5G Ethernet-based fronthaul architecture, 100G trunk lines of a transmission distance up to 10 km standard single mode fiber (SSMF) in combination with cheap grey optics to daisy chain cell site network interfaces are a promising cost- and power-efficient solution. For such a scenario, different intensity modulation and direct detect (IMDD) Formats at a data rate of 112 Gb/s, namely Nyquist four-level pulse amplitude modulation (PAM4), discrete multi-tone Transmission (DMT) and partial-response (PR) PAM4 are experimentally investigated, using a low-cost electro-absorption modulated laser (EML), a 25G driver and current state-of-the-art high Speed 84 GS/s CMOS digital-to-analog converter (DAC) and analog-to-digital converter (ADC) test chips. Each modulation Format is optimized independently for the desired scenario and their digital signal processing (DSP) requirements are investigated. The performance of Nyquist PAM4 and PR PAM4 depend very much on the efficiency of pre- and post-equalization. We show the necessity for at least 11 FFE-taps for pre-emphasis and up to 41 FFE coefficients at the receiver side. In addition, PR PAM4 requires an MLSE with four states to decode the signal back to a PAM4 signal. On the contrary, bit- and power-loading (BL, PL) is crucial for DMT and an FFT length of at least 512 is necessary. With optimized parameters, all Modulation formats result in a very similar performances, demonstrating a transmission distance of up to 10 km over SSMF with bit error rates (BERs) below a FEC threshold of 4.4E-3, allowing error free transmission.

Improving Performance of Mobile Fronthaul by High-Order Delta-Sigma Modulation Based on PAM-4 IM-DD Channels

Hybrid Fiber-Thz Fronthaul Supporting Up to 16384-QAM-OFDM with the Delta-Sigma Modulation

Delta-sigma Modulation for Digital Mobile Fronthaul Enabling Carrier Aggregation of 32 4G-LTE / 30 5G-FBMC Signals in a Single-Λ 10-Gb/s IM-DD Channel

Digital mobile fronthaul based on delta-sigma modulation for 32 LTE carrier aggregation and FBMC signals

Support 16384QAM Mobile Fronthaul Based on 3 Amplitude Quantization Delta-Sigma Modulation

High tolerance against chirp induced distortions in PAM4-based digital mobile fronthaul by sample bits interleaving

10-Gbaud OOK / PAM4 Digital Mobile Fronthaul based on One-Bit / Two-bit Delta-Sigma Modulation Supporting Carrier Aggregation of 32 LTE-A Signals

NTF-Improved Delta-Sigma Modulation Supported 65536 QAM Signal for Mobile Fronthaul

Digital Code-Division Multiplexing Channel Aggregation for Mobile Fronthaul Architecture With Low Complexity

Digital Mobile Fronthaul based on Delta-sigma Modulation and Chirp-managed Signal Transmission

Application of Chirp-managed Laser and Bits-Interleaving in Digital Mobile Fronthaul

Digital Mobile Fronthaul Scheme Based on Diff-Delta-Sigma Modulation and OCT Precoding

Performance Comparison of 112 Gb/s DMT, Nyquist PAM4 and Partial-Response PAM4 for Future 5G Ethernet-based Fronthaul Architecture

60 Gbit/s PAM-4 Wireless Transmission in the 310 GHz Band with Nonlinearity Tolerant Signal Processing

Experimental Demonstration of a 96 Channel WDM-FSO System Based Mobile Fronthaul with 1024QAM Delta-Sigma-Modulation.

Chromatic Dispersion Robust Delta-Sigma Modulation for High-Order QAM Mobile Fronthaul

MZM Nonlinearity Enabled Uneven PAM-4 for EVM Reduction in Digital Mobile Fronthaul

SNR-enhanced Signal Delivery Scheme with Delta-Sigma Modulation in a Four-Mode Fiber System

Mobile 14-Ghz Bandwidth Fronthaul Link Supporting 128 RF-Chain Signals for 6G Ma-MIMO Beamforming

135-GHz D-Band 60-Gbps PAM-8 Wireless Transmission Employing a Joint DNN Equalizer With BP and CMMA

Design Optimization of Feedforward Equalization for Mobile Fronthaul Based on Delta-Sigma Modulation With High-Order QAM Signals