Abstract:The modular multilevel converter (MMC) with nearest level modulation (NLM) is widely used in the high voltage applications for low switching frequency and easy implementation. Existing literature has not provided a complete submodule (SM) fault ride-through scheme for MMC with NLM. In this paper, a strategy including fault detection, localization, redundancy, and recovery is proposed to ensure continuous operation of MMC under IGBT open-circuit faults conditions. It only requires a few hardware and software resources. The features of MMC and SMs with three types of failures are studied, respectively. Based on these, the fault detection method is proposed by using a simple hardware circuit, thus high computation complexity is avoided. Since current fault localization schemes are limited to MMC with carrier phase shifted pulse width modulation, this paper further proposes a strategy for MMC with NLM to locate the faulty SM and identify the fault type. After this, the fault redundancy and the proposed fault recovery method are applied to eliminate the fault and then exit the failure state. Therefore, the ability of SM fault ride-through can be realized. Analysis of failure characteristics are verified in simulation. Experimental results based on a single-phase MMC prototype with 11 SMs per arm are presented to demonstrate the validity of the proposed fault ride-through strategy.

A zero-sequence voltage injection control scheme for modular multilevel converter under submodule failure

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Fluctuation Voltage Control and Fault-Tolerant Operation of Modular Multilevel Converters with Zero-Sequence Injection

Fault-tolerant Control for Modular Multilevel Converter Based on Zero-sequence Voltage Injection

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

Common‐mode Voltage Injection‐based Nearest Level Modulation with Loss Reduction for Modular Multilevel Converters

A Novel Fault-Tolerant Control of Modular Multilevel Converter under Sub-Module Faults Based on Phase Disposition PWM

Analysis and Injection Control of Zero-sequence Voltage and Circulating Current for MMC with Active Power Filter

Analysis and Injection Control of Circulating Current for Modular Multilevel Converters

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

Low Frequency Operation Control Method for Modular Multilevel Converter Based on Improved Arm Current Prediction

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Fault-Tolerant Control of Medium-Voltage Modular Multilevel Converters with Minimum Performance Degradation under Submodule Failures

Implementation of Space Vector Modulation (SVM) for Modular Multilevel Converter Based on Submodule Regroup

Low-Frequency Control Strategy for a Modified Modular Multilevel Converter

Introduction, Modeling and Simulation of Modular Multilevel Converter

A Rotation-Based Capacitor-Voltage-balancing Method for Modular Multilevel Converters

AC and DC Current Hybrid Control Strategy for Modular Multilevel Converter

A Simplified Space Vector Modulation Implementation for Modular Multilevel Converter by Grouping Submodules

Semi‐hot Redundant Control Method for Modular Multilevel Converter‐based High‐voltage Direct Current Systems under Submodules Fault