Abstract:Thermal control device based on thermochromis plays an important role in spacecrafts thermal management by automatically adjusting its radiative properities in response to large temperature gradients. The thermal management ability was determined by the device surface radiation performance. During the sun shadow, it is required to dissipate heat as little as possible from spacecraft, which is a low emittance device. While, it desired the device emittance is large enough to meet the heat dissipation requirement facing with the direct sunlight. As a type thermochromic material, La1 - x Sr x MnO3 (LSMO) has obtained broad attention because it showed a considerable superiority in saving energy consumption in space thermal management. It can hold the heat at low temperature due to its low emittance behavior, whereas dissipate the excess heat at high temperature for its high emittance properties. In this work, we prepared the La1 - x Sr x MnO3 ( x= 0125, 0.175, and 0.2) nanoparticles by sol-gel method from the precursors such as lanthanum nitrate hexahydrate, strontium nitrate and manganese nitrate solution (50%). LSMO nanoparticles were dispersed homogeneously in a solution of resins. The mixture then was spin-coated on the clean Al substrates. After standing for 10 h, the coating was cured at 120°C. The structure, morphology, and composition analysis of LSMO nanoparticles or coatings were investigated by X-ray diffraction technique, scanning electron microscopy, and the energy dispersive X-ray spectroscopy, respectively. The total hemispherical emittance of coating was measured by calortmetric method, which test sample was suspended in the center of a liquid nitrogen thermostat. According to the input power, sample temperature, and thermostat temperature, the emittance can be indirectly obtained. Two resins, which is the acrylic resin and the solution of terpineol and ethyl cellulose respectively, was considered to investigated the effect of reslin type on the emittance of coatings. The result of X-ray diffraction shows a single perovskite structure for LSMO nanoparticles at different Sr doped level. A fined LSMO nanoparticle with 50–300 nm, which is detected using scanning electron microscopy, can be obtained by control sol-gel process. The composition analysis results show a comparable stoichiometric ratio. The two resins coating show a different surface morphology, which is more compact in acrylic resin than in the terpineol. Experimental results show that the variation amplitude of coating emittance is 0.45 within the temperature range of 173–370 K. For the acrylic resin coating, the emittance changes from 0.42 at 173 K to 0.85 at 370 K, and it rises from 0.39 at 173 K to 0.83 at 370 K in terpineol resin coating.

Nanometer Thick Thermochromic Film Based on K-Doped Manganite Oxide Prepared by Magnetron Sputtering

Temperature-dependent Emissivity Property in La0.7Sr0.3MnO3 Films

Radiative Properties of Thermochromic Material with Solar Reflection Films

Tailoring the Solar Absorptivity of Thermochromic Material La0.7ca0.2sr0.1mno3

Preparation and Structure of La_(0.5)Ca_(0.5)Mn_xTi_(1-x)O_3 Thin Film Deposited by Magneto Controlled Sputtering

Variable Emissivity Property of Magnetron Sputtering Thermochromic Film

Adjusting the K-doping of La1-K MnO3 (0.1 ≤ x ≤ 0.35) films to obtain high TCR and LFMR at room-temperature

Superior La0.67K0.33-Sr MnO3 films with room-temperature TCR prepared by spin coating method

Optimization of the electrical transport properties of La0.7Ca0.3MnO3 films by sintering temperature adjustment

Structural, magnetic and magnetocaloric properties of hexagonal MnCoGe-based thin films

Perovskite-type oxide films combined with gratings for reduction of material consumption and improvement of thermochromism property

Changing the Ca2+ ion ratio to modulate the temperature coefficient of resistivity (TCR) of La1-Ca MnO3 films prepared by the sol-gel spin coating method

(1-x)Mn1.56Co0.96Ni0.48O4/xLaMnO3 (0.1≤x≤0.9): A composite NTC thin film with low resistance, high sensitivity and strong light absorption

Temperature-dependent Infrared Properties of Ca Doped (la,sr)mno3 Compositions with Potential Thermal Control Application

The dielectric behavior and efficient microwave absorption of doped nanoscale LaMnO3 at elevated temperature

Thermochromic VO2 thin films: solution-based processing, improved optical properties, and lowered phase transformation temperature

Efficient preparation of the inclined La<sub>1-x</sub>Ca<sub>x</sub>MnO<sub>3</sub> films with excellent light-induced transverse thermoelectric performance based on MOCVD process

Infrared optical properties modulation of VO2 thin film fabricated by ultrafast pulsed laser deposition for thermochromic smart window applications

Total Hemispherical Emittance of Low Temperature Curing Thermochromic Coatings

Exploring the substrate-driven morphological changes in Nd0.6Sr0.4MnO3 thin films

Flexible Thermochromic Foil Derived from Fine Perovskite Nanoparticles with Excellent Energy‐saving Performance