Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Analysis and Suppression of Magnetically Levitated Rotor Vibration Influence for High-Speed Permanent Magnet Motor Sensorless Control

Analysis and Suppression of Rotor Eccentricity Effects on Fundamental Model Based Sensorless Control of Permanent Magnet Synchronous Machine

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Research on Rotor Position Estimation Method of Sensorless Permanent Magnet Synchronous Motor

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Position Sensorless Control of Permanent Magnet Synchronous Motor Based on High Performance Flux Estimation Algorithm

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Sensorless Estimation and Convergence Analysis Based on MRAS for PMSM

Sensorless control and start-up strategy of permanent magnet synchronous motor

Rotor Position Estimation Of Sensorless Pmsm Based On Extented Kalman Filter

Sensorless Operation Of An Inset Pm Bearingless Motor Implemented By The Combination Approach Of Mras And Hf Signal Injectionac

Research of Sensorless Control for Permanent Magnet Synchronous Motor Systems

Rotor Position Estimation Approaches for Sensorless Control of Permanent Magnet Traction Motor in Electric Vehicles: A Review

Speed Sensorless Control for Permanent Magnet Synchronous Motors Based on Finite Position Set

Permanent magnet synchronous motor sensorless control based on rotor flux observer with low-pass filter adaptation

Speed Adaptative Sensorless Control Method of a High-speed Dual Three-phase Permanent Magnet Synchronous Motor

Sensorless Technique for Permanent Magnet Synchronous Motor with Wide-Speed-Range

Sensorless Control of Permanent Magnet Synchronous Motor — a Survey

A Novel Rotor Position Detection Method for Sensorless Control of Magnetic-Geared Permanent-Magnet Brushless Motor