Abstract:Ultraviolet photocatalytic oxidation (UVPCO) systems for removal of volatile organic compounds (VOCs) from air are being considered for use in office buildings. Here, we report an experimental evaluation of a UVPCO device with tungsten oxide modified titanium dioxide (TiO2) as the photocatalyst. The device was challenged with complex VOC mixtures. One mixture contained 27 VOCs characteristic of office buildings and another comprised 10 VOCs emitted by cleaning products, in both cases at realistic concentrations (low ppb range). VOC conversion efficiencies varied widely, usually exceeded 20%, and were as high as approximately 80% at about 0.03 s residence time. Conversion efficiency generally diminished with increased airflow rate, and followed the order: alcohols and glycol ethers > aldehydes, ketones, and terpene hydrocarbons > aromatic and alkane hydrocarbons > halogenated aliphatic hydrocarbons. Conversion efficiencies correlated with the Henry's law constant more closely than with other physicochemical parameters. An empirical model based on the Henry's law constant and the gas-phase reaction rate with hydroxyl radical provided reasonable estimates of pseudo-first order photocatalytic reaction rates. Formaldehyde, acetaldehyde, acetone, formic acid and acetic acid were produced by the device due to incomplete mineralization of common VOCs. Formaldehyde outlet/inlet concentration ratios were in the range 1.9-7.2. Practical implications: Implementation of air cleaning technologies for both VOCs and particles in office buildings may improve indoor air quality, or enable indoor air quality levels to be maintained with reduced outdoor air supply and concomitant energy savings. One promising air cleaning technology is ultraviolet photocatalytic oxidation (UVPCO) air cleaning. For the prototype device evaluated here with realistic mixtures of VOCs, conversion efficiencies typically exceeded the minimum required to counteract predicted VOC concentration increases from a 50% reduction in ventilation. However, the device resulted in the net generation of formaldehyde and acetaldehyde from the partial oxidation of ubiquitous VOCs. Further development of the technology is needed to eliminate these hazardous air pollutants before such a UVPCO device can be deployed in buildings.

Experiments and Kinetics of Solar PCO for Indoor Air Purification in PCO/TW System

Thermal catalytic oxidation performance study of SWTCO system for the degradation of indoor formaldehyde: Kinetics and feasibility analysis

The Performance Analysis of a Novel Photocatalytic-Thermal-catalytic-photovoltaic-trombe Wall System Integrated with Compound Parabolic Concentrator

Numerical Simulation of a UV-PCO Plate Reactor

Photocatalytic Oxidation for Indoor Air Purification: a Literature Review

Air Purification and Thermal Performance of Photocatalytic-Trombe Wall Based on Multiple Physical Fields Coupling

Indoor formaldehyde removal by thermal catalyst: kinetic characteristics, key parameters, and temperature influence

Removal of formaldehyde in urban office building by the integration of ventilation and photocatalyst-coated window

Performance Study on a Novel Hybrid Solar Gradient Utilization System for Combined Photocatalytic Oxidation Technology and Photovoltaic/thermal Technology

Study on the performance of a novel photovoltaic/thermal system combining photocatalytic and organic photovoltaic cells

Modeling of ternary mixture of VOCs in photocatalytic oxidation reactor for indoor air quality application

Performance Study of Organic Photovoltaic/thermal System with Synergistic Effect of Photocatalytic and Thermal Catalytic Technology

Design Consideration of Photocatalytic Oxidation Reactors Using TiO2-coated Foam Nickels for Degrading Indoor Gaseous Formaldehyde

A Methodology for Modeling Photocatalytic Reactors, Application to the Degradation of Formaldehyde

Research of formaldehyde removal by room temperature thermo-catalytic oxidation reactor

Photocatalytic Purification of Volatile Organic Compounds in Indoor Air: A Literature Review

Experiment on eliminating formaldehyde by photocatalysis in central air conditioning systems

Experimental and Numerical Performance Analysis of a TC-Trombe Wall

Multifunctional Solar Wall for Dehumidification, Heating and Removal of Formaldehyde: Part 1. System Description, Preparation and Performance of SiO2/TiO2 Adsorbent

Performance of ultraviolet photocatalytic oxidation for indoor air cleaning applications

The Design and Analysis of a Novel Tubular Foam-Nickel Photocatalytic Air Purifier