Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Influence of Fuel Additives in the Urea-Nitrates Solution Combustion Synthesis of Ni-Al2o3 Catalyst for Slurry Phase Co Methanation

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Solution-combusted nanosized Ni–Al2O3 catalyst for slurry CO methanation: effects of alkali/alkaline earth metal chlorides

Catalytic Performance for CO Methanation over Ni/MCM-41 Catalyst in a Slurry-Bed Reactor

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Optimized combustion temperature in the facile synthesis of Ni/Al2O3 catalyst for CO2 methanation

Numerical Investigation of the Effect of Ammonia Addition on the Performance of a Stoichiometric Operated Natural Gas Spark Ignition Engine

Development of Highly Stable Ni-Al 2 O 3 Catalysts for CO Methanation

Improving Anti-Coking Properties of Ni/Al2O3 Catalysts via Synergistic Effect of Metallic Nickel and Nickel Phosphides in Dry Methane Reforming

Facilely Fabricating Highly Dispersed Ni-based Catalysts Supported on Mesoporous MFI Nanosponge for CO2 Methanation

Nickel catalyst prepared via glycine nitrate process for partial oxidation of methane to syngas

Physicochemical properties of Ni/γ-Al2O3-AlN and effects of AlN on catalytic performance of Ni/γ-Al2O 3-AlN in partial oxidation of methane

Nickel Hydroxide Nanosheets Prepared by a Direct Manual Grinding Strategy for High-Efficiency Catalytic Combustion of Methane

A High Loaded Catalyst of Highly Dispersed Nickel Species on Acid-Treated Mesoporous Clay Layers for Efficient CO and CO2 Methanation

Study on Methanation Performance of Biomass Gasification Syngas Based on a Ni/Al2O3 Monolithic Catalyst

Aqueous Miscible Organic LDH Derived Ni-Based Catalysts for Efficient CO2 Methanation

Facile preparation of a Ni/MgAl2O4 catalyst with high surface area: enhancement in activity and stability for CO methanation

Exploring the Influence of Nickel Precursors on Constructing Efficient Ni-based CO2 Methanation Catalysts Assisted with In-Situ Technologies

Facilely Preparing Highly Dispersed Ni-Based Co2 Methanation Catalysts Via Employing the Amino-Functionalized Kcc-1 Support

Ammonia partial cracking over low-cost Ni catalysts for enhancing combustion

Synergistic effect of Ni and NiO in hydrogen reduction for CO methanation