DC-Current-Limiting Characteristics of YBCO Tapes for DC Currents of 50 A to 10 Ka

Bin Xiang,Kun Yang,Yaxiong Tan,Zhiyuan Liu,Yingsan Geng,Jianhua Wang,Satoru Yanabu
DOI: https://doi.org/10.1109/tasc.2017.2652490
IF: 1.9489
2017-01-01
IEEE Transactions on Applied Superconductivity
Abstract:The amplitude and rise time of fault currents can be reduced by installing a resistive-type superconducting fault current limiter (SFCL) in a voltage-source converter high-voltage DC (VSC-HVDC) system. Such an SFCLcan provide sufficient time for a mechanical-type dc circuit breaker to interrupt a fault current. The objective of this paper is to elucidate the dc-current-limiting characteristics of Yttrium Barium Copper Oxygen (YBCO)-coated conductor tapes for a wide range of prospective currents ( ranging from 50 to 10 kA). The factors investigated include critical currents (Ic) of the tape of 102 and 225 A, circuit time constants of 1 and 3 ms, and rated dc voltages of 250 and 500 V. The experimental results show that the limited current remains nearly constant with prospective current when the prospective current is higher than ten times Ic. The circuit time constant affects only the peak value and rise rate of the limited current. A single tape ( I-c = 102 A) can limit a 10-kA prospective current to a peak value of 555 A. The limited current for a rated voltage of 500 V is always higher than that for a rated voltage of 250 V.
What problem does this paper attempt to address?