Abstract:Due to excavation disturbances and the coupled hydro-mechanical effects, deep rock masses experience nonlinear large deformations in the surrounding rock, necessitating an urgent exploration of the rock damage and failure mechanisms from the perspectives of hydro-mechanical coupling and mechanical properties. Therefore, this study conducted uniaxial cyclic loading-unloading tests on sandstone samples with different water contents (0%, 0.26%, 0.52%, 0.78%, and 1.04%) to investigate the microstructural evolution, energy evolution laws, and failure characteristics under varying water contents and cyclic loading conditions. The main conclusions are as follows:(1) Concerning micro-pore structures, as the water content increases, the porosity and maximum pore size of the sandstone first decrease and then increase. At 0% water content, the porosity is 4.82% and the maximum pore size is 31.94 μm. At 0.26% water content, both porosity and maximum pore size decrease to 3.03% and 16.15 μm, respectively. When the water content reaches 1.04%, the porosity and maximum pore size increase to 14.34% and 45.99 μm, respectively. (2) Regarding energy evolution laws, the energy evolution of the specimens during cyclic loading-unloading mainly converts to elastic energy, showing a step-wise increase in energy. Further analysis reveals that the water content has a significant impact on the dissipation energy coefficient of the sandstone. At lower stress levels (<0.4σ max ), the water content has a negligible effect, while at higher stress levels (>0.85σ max ), an increase in water content leads to increased fluctuations in the dissipation energy coefficient. (3) In terms of failure characteristics, with increasing water content, the failure mode of the specimens shifts from primary crack failure to microcrack failure, corresponding to the energy evolution during cyclic loading-unloading processes.

Influence of Cyclic Wetting and Drying on Physical and Dynamic Compressive Properties of Sandstone

Degradation of Strength and Stiffness of Sandstones Caused by Wetting-Drying Cycles: The Role of Mineral Composition

Experimental Study on Dynamic Compression Characteristics of Red Sandstone under Wetting-Drying Cycles

Influence of Drying-Wetting Cycles on Dynamic Tensile Properties of Red-Sandstone Using the Brazilian Test

Assessments of Tensile Characteristics and Degradation Mechanism of Sandstone Subjected to Wetting–Drying Cyclic Treatment

Fracture behavior and damage mechanisms of sandstone subjected to wetting-drying cycles

Multi-scale Experimental Investigations on the Deterioration Mechanism of Sandstone Under Wetting–Drying Cycles

Deterioration of dynamic fracture characteristics, tensile strength and elastic modulus of tight sandstone under dry-wet cycles

Effect of Water Saturation on Dynamic Behavior of Sandstone after Wetting-Drying Cycles

Experimental Study on the Deterioration Mechanism of Sandstone under the Condition of Wet-Dry Cycles

Investigating the impact of the quantity of wet and dry cycles on the mechanical characteristics and fracture variations of sandstones

Deterioration of Physical and Mechanical Properties of Rocks by Cyclic Drying and Wetting

Effects of dry-wet cycles on the mechanical properties of sandstone with unloading-induced damage

Effects of Cyclic Wetting-Drying on the Mechanical Behavior and Improved Damage Model for Sandstone

Mechanical properties and energy evolution law of water bearing sandstone under cyclic loading

Water saturation effects on dynamic behavior and microstructure damage of sandstone: Phenomena and mechanisms

Effects of cyclic freezing and thawing on the mechanical behavior of dried and saturated sandstone

Study on the change of physical properties of sandstone under action of acidic drying-wetting cycles and discrete element simulation

Effect of Dry–Wet Cycling on the Degradation Characteristics and Mechanisms of Red Sandstone

Effects of Water and Cyclic Loading on Ultrasonic and Mechanical Properties of Sandstone: An Experimental Study

Analysis of mechanical properties and deterioration mechanisms of mudstone under wetting-drying cycles