Abstract:Up to now, the installation capacity in China is more than 440,000MW. It stimulates cable manufacturing industry and operating system. In 2004, increasing power lines of 330kV and higher was 11,421km, including 1,857km DC, and in 2005, the power line of 220kV and higher is 25,000km. Transforming capacity is about 140,000MVA. It predicates that Chinese power wire and cable industry has entered into a period of rapid progress. XLPE cable become a main part of power cables not only in middle and low voltage systems, but in high voltage ones of 220kV and higher. 500kV XLPE cable was produced in the year of 2004, and large-length submarine XLPE cable was produced and served in the power system in 2002. Comparing with those, high-voltage cable accessories have not been produced as a complete set, even though new materials and configuration for the accessories are under research. The HTS cable of 35kV has been manufactured and passed through the certification test in 2004. There are two independent power grid management systems. Cable construction and operation system also change remarkably. There are mainly 3 systems of underground cable layings in China, i.e. the pipeline, trench and tunnel. Considering the cost and time limit for a project, pipeline laying is a better method. It has been widely used during the process of power cables to be laid underground in cities of China, and it is also the tendency in the future. The cable insulation on the bridge and under the water has new requirement not only for construction and properties of the cables, but also on installation technology. Large-length cables on the bridge and under the water has been installed and operated successfully. All of these improved the technology progress on Chinese cable manufacturing and operating. Technical failures and accidents also occurred during the cable operation, which show that there are deficiencies in the progress of Chinese cable technology, including cable breakdown due to the insulation quality, water immersion, especially in the joints. Fire-proof technology is very important to cable system as well. Biological infestation for cables should be paid attention also, for example, termite and rat. All of these are introduced in this paper in detail.

Power Cable Condition Monitoring in a Cable Tunnel: Experience and Inspiration

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Characteristics of Power Frequency Magnetic Field for AC Cable Circuits Laying in Tunnels

Online multi-parameter sensing and condition assessment technology for power cables: A review

A Technique for Assessment of Thermal Condition and Current Rating of Underground Power Cables Installed in Duct Banks

Research and Application of Online Temperature and Load Monitoring for Power Cables

Key technology for the construction and inspection of long-distance underwater tunnel for 1000 kV gas-insulated transmission line

Design of Power Cable Data Monitoring and Forecasting System for Utility Tunnel Based on edge computing

Research on Temperature Monitoring and Warning System for Power Cable Joints

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Method For Tunnel Life-Cycle Heath Monitoring Based On Distributed Optical Fiber Sensor

Underground Power Cable Fault Detection and Localization Based on the Spectrum of Propagation Functions

Development of cable products and systems in China in recent years

Online Monitoring of Power Cables Tangent Delta Based on Low-Frequency Signal Injection Method

Underground Power Cable Detection and Inspection Technology Based on Magnetic Field Sensing at Ground Surface Level

Amplitude Distribution of Partial Discharge Signals on Tunnel-Installed High-Voltage Cables

Investigation of On-line Monitoring Method on 1500 V Direct Current Cable of Subway

On-line monitoring techniques for 110 kV and above XLPE cable

The Design of Distributed On-Line Monitoring System for Metal Sheath'S Circulating Current of Cross-Linked Power Cables