Abstract:This paper presents a new protection scheme for high-speed protection of transmission lines, the Integrated Positional Protection scheme. The concept of integrated protection is firstly introduced, in which a centralized protection relay provides the protection for multiple transmission lines. The proposed scheme is based on a specially integrated relay unit, which is installed at each substation of a network and responsible for the protection of all the line sections associated with the substation. The relay based on the detection and processing of fault generated high frequency transient current signals incorporates two novel protection principles and their application techniques, which are the positional protection techniques with and without the synchronization of Global Positioning System (GPS) respectively. The technique without the need for GPS synchronization is a non-unit protection technique, which does not require a communication link. The decision to operate is based on the detection of the relative arrival times of these high frequency components at the relay location as they propagate through the system. The basic principle of the GPS based technique is to detect the fault generated high frequency transient signals and record the time instant corresponding to when the initial travelling wave generated by the fault arriving at that busbar. A communication gateway is used to transmit and receive coded digital signals of the local information to and from the associated relay(s) in the system. At each substation, the relays determine the location of the fault by comparing the GPS time stamps measured locally with those received from the adjacent substations. Simulation studies of the scheme were carried out to examine the response to different power system and fault conditions. Results show that the scheme is insensitive to fault type, fault resistance, fault inception angle and system source configuration, and is able to offer both very high accuracy and - speed in fault detection.

Dynamic state estimation based protection of mutually coupled transmission lines

Dynamic State Estimation Based Protection on Series Compensated Transmission Lines

Dynamic State Estimation Based Protection for Flexible DC Grid

Protection of Multi-Terminal Hybrid Transmission Lines Based on Dynamic States Estimation

Dynamic State Estimation-Based Fault Locating on Transmission Lines

Dynamic State Estimation Based Unit Protection

Dynamic state estimation based protection using multi-section multi-layer frequency dependent line model for underground cables in MMC-HVDC grids

Improved Dynamic State Estimation Based Protection on Transmission Lines in MMC-HVDC Grids

Improved Dynamic State Estimation Based Protection on VSC-HVDC Transmission Lines with Full Exploitation of Information Redundancy

Dynamic State Estimation-Based Protection: Status and Promise

Hybrid Multi-Infeed Receiver Line Longitudinal Protection Scheme Based on Voltage Waveform Comprehensive Distance Similarity

Distance protection on mmc-hvdc transmission lines with single-ended measurements

CURRENT-TRAVELLING-WAVE-BASED PROTECTION OF DOUBLECIRCUIT TRANSMISSION LINE

Protection and Fault Locating Method of Series Compensated Lines by Wavelet Based Energy Traveling Wave

Improved distance protection for wind farm transmission line based on dynamic frequency estimation

A centralized protection scheme based on combined positional protection techniques

MMC-HVDC Transmission Line Protection Based on Bergeron Model and State Estimation

Fast and reliable differential protection based on traveling waves for HVDC transmission line

Transmission Line Differential Protection Based on Numerical Solution of Partial Differential Equations

Physics-Informed Data-Driven Transmission Line Fault Location Based on Dynamic State Estimation

Long Transmission Line Distance Protection Based on Parameter Identification in Time Domain