Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. To improve the dynamic load-sharing performance and achieve lightweight, the twin rotors concentric face gear power-split transmission system (TRFGPSTS) was optimized. The gear tooth matching conditions of the system based on the design characteristics of power flow closed-loop and virtual constraint configuration of the system are established, and the basic parameters of each gear meet the requirements of the system load-sharing layout and synchronous meshing of each branch movement are calculated. Based on the lumped mass parameter method, combined with the calculation results of gear tooth matching, the 45-DOF bending torsional coupling dynamic model of the system was established considering time-varying meshing stiffness, support stiffness, manufacturing and installation errors, and other factors, and the influence of each factor on the dynamic load-sharing performance of the system was analyzed. Combined with the influence law of various factors, a multi-objective dynamic load-sharing optimization design model was established with the best dynamic load-sharing performance and the minimum system quality as the objective function. Through the weighted combination method, the global optimal solution of the system optimization design was determined, and the influence of each parameter on the optimization objective function was analyzed. The correctness of the results was verified by using the genetic algorithm based on Pareto frontier distribution. The results show that the dynamic load-sharing characteristics of the system become worse with the increase of error and torsional stiffness, and are more sensitive to the influence of various error parameters. The optimization process focuses on the geometric parameters such as the Module, the teeth Number, the Pressure angle, and the Tooth width of each gear, which can reflect the degree of influence on the dynamic load-sharing and lightweight of the system. After optimization, the dynamic load sharing coefficient (DLSC) was reduced to 1.017, and the overall geometric volume was reduced to 1.473 × 108 mm3. It provides a theoretical basis for the design and research of a new type of helicopter power transmission system with a compact structure, good maneuverability, and high reliability.

The Structure Optimization of Test-Bed for Load Bearing Performance of Harmonic Gear Drive

Research on Test System of Comprehensive Transmission Performance of Wide-range Gears

Structural Optimization of a Novel Coaxial Magnetic Gear

Loading Methodology and Dynamics Analysis of the Digital-Servo Hydraulic Cylinders Group in Large Wind Turbine Drivetrain Test Bench

Heat-Structure Coupling Analysis of Harmonic Drive under Different Thermal Loading

Design optimization of a wind turbine gear transmission based on fatigue reliability sensitivity

Dynamics Modeling and Load-Sharing Performance Optimization of Concentric Face Gear Split-Torque Transmission Systems

Research on Optimization of Face Gear Grinding Machine Structure Design Based on Dynamic Performance of Machine Tool

Calculating the Load Distribution and Contact Stress of the Disposable Harmonic Drive under Full Load

Dynamic modeling and analysis for a drive axle gear transmission system

OPTIMIZATION OF COMPOUND PLANETARY GEAR TRAIN BY IMPROVED MESH STIFFNESS APPROACH

Development of Test Rig for High-Speed Railway Rolling Bearings

Optimization design of load-sharing and light weight of the twin rotors concentric face gear power-split transmission system based on gear tooth matching condition

Simulation and experimental test of load-sharing behavior of planetary gear train with flexible ring gear

Dynamic reliability based design optimization of the lifting gear transmission system for mining excavator

Study on Dynamic Coupling Behavior of End-Meshing Harmonic Reducers

Analysis of the Partial Axial Load of a Very Thin-Walled Spur-Gear (Flexspline) of a Harmonic Drive

FE-analytical slice model and verification test for load distribution analysis and optimization of planetary gear train in wind turbine

Structural design and dynamic analysis of a metal rubber composite gear pair

Solid Modeling And Finite Element Analysis Of Harmonic Drive With Wide Slot Involute Tooth Profile

Modal analysis and structural optimization of heavy duty marine gearbox