Abstract:This study presents the numerical analysis of single-phase forced convection heat transfer and pressure drop during internal flow in a shallow, rectangular sandwich-like copper channel heated from both the top and the bottom. Simulations were conducted using a commercial finite volume solver that solves governing continuity, momentum, and energy equations simultaneously. The bottom side of the channel was considered with arrays of rectangular miniature-pin fins. The miniature-pin fin geometry was modeled in a staggered configuration with tip clearance from the opposite surface while the orientation of the fins was directed parallel to the flow direction of the working fluid. Water was used as a working fluid with a fully developed velocity profile at the channel entry. Simulations were carried out for varying inlet temperatures and mass flow rates. All calculations were performed with the RNG k-ε model to model complex turbulent flows appropriately. Grid independence and validation analyses were also conducted. With the validated model, additional analyses were performed for 0, 0.1, 0.3, 0.6, and 1 mm tip clearances, and correlations were proposed after performing regression analyses for the friction factor and heat transfer coefficient. The calculations revealed that in contrast to a straight (nonfinned) surface, up to 220% larger heat transfer coefficients could be obtained for the finned surfaces under comparable operating conditions. It was also shown that tip clearance in turbulent flow affects heat transfer negatively. With increasing clearance, the Nusselt number decreased; in other words, heat transfer worsened. On the other hand, the use of miniature-pin fins led to a rise in the pressure drop over the entire heated length. For the Reynolds number spectrum of 4000–20000, the ratio of the friction coefficient of the finned surface to the friction coefficient of the nonfinned surface varied from 6 to 5 while with a further reduction in pressure loss a value of approximately 4 could be obtained for larger tip clearances. Hence, with larger tip clearances, the friction factor decreased, reflecting the abatement of pressure loss.

Numerical study on the heat transfer of micro elliptic pin fins in a rectangular minichannel

Numerical Study on Performances of Mini-Channel Heat Sinks with Non-Uniform Inlets

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Numerical Study on Heat Transfer Performance of a New-proposed Pin-fin in an Internal Channel

Numerical study of the intensification of single-phase heat transfer in a sandwich-like channel using staggered miniature-pin fins

Comparative studies on heat transfer and flow resistance of nanofluid in microchannels with different sidewall micro-fins

Optimization of elliptical pin-fin microchannel heat sink based on artificial neural network

Research on the mechanism of heat transfer enhancement in microchannel heat sinks with micropin fins

Numerical Investigation of Fluid Flow and Heat Transfer in High-Temperature Wavy Microchannels with Different Shaped Fins Cooled by Liquid Metal

Numerical study of the influence of pin fin arrangement and volume fraction on the heat transfer and fluid flow phenomena within open microchannels

Heat Transfer Enhancement of Microchannel Heat Sink Using Sine Curve Fins

Convective heat transfer of microchannel heat sinks with pinfins and jets for a heat flux up to 500 W/cm 2

Study on the flow and heat transfer characteristics of pin-fin manifold microchannel heat sink

Pore-scale Simulation of Flow in Minichannels with Porous Fins

Investigation on thermal performance of nanofluids in a microchannel with fan-shaped cavities and oval pin fins

Enhanced heat transfer of heat sink channels with micro pin fin roughened walls

Numerical Study of the Temperature Effects on Heat Transfer Coefficient in Mini-Channel Pin-Fin Heat Sink

Influence of fin length and width on flow and heat transfer performance of miniature heat sinks

Numerical Investigation of Enhanced Heat Transfer with Micro Pin Fins in Heat Exchangers

Heat transfer enhancement using combined microchannel with vertical rectangular micro fins

Effects of pin fins and vortex generators on thermal performance in a microchannel with Al2O3 nanofluids