Abstract:According to the characteristics of energy acquisition applied to tags, a monitoring circuit was added between the energy acquisition module and the tag module, and the cooperative working strategy of energy acquisition and tags was put forward based on the setting of high and low thresholds. The low threshold selection principle is to ensure that the energy storage of the energy storage module can ensure the one-time broadcasting of the tag and prevent the tag from entering the power down state to the maximum extent. The optimal value of energy storage capacitance, minimum and optimal radio frequency (RF) input power in the environment were deduced by starting from the broadcast interval and power required in the tag design goal according to the amount of energy that can be collected in the environment and the change of energy consumption required by the tag in different states. A tag based on RF acquisition was designed by using P2110B and CC2640R2F chip for verification. Test results show that the energy acquisition tag designed by this method can realize the cooperative work of energy acquisition module and tag module. The tag can carry out continuous “sleep and broadcast” cycle when the RF input power is greater than the optimal value. It can effectively prevent the label from falling into “energy deadlock”, and can adaptively switch in different working states.

A low power high sensitivity RF power detector for multi-mode active tags

A 25-31Ghz Compact True Power Detector with >33db Dynamic Range in 40nm Bulk CMOS

A Low Power,Large Dynamic Range 915mhz Passive RFID Tag

Low Modulation Index RF Signal Detection for a Passive UHF RFID Transponder

Design method of electronic tag based on radio frequency energy acquisition

Design and Implementation of a High Sensitivity Fully Integrated Passive UHF RFID Tag

Design and Implementation of an Ultra-Low Power Passive UHF RFID Tag

A high-efficient energy harvest chain for ultra-low power passive UHF RFID tags

Low Power Design of RFID Tags

A 6.93 Mu W Wake-Up Circuit For Active Rfid Tags

Analysis and Design of Power Efficient Semi-Passive Rfid Tag

Research of Photodiodes and Optical Tags in Standard CMOS Process

Fully Integrated Passive UHF RFID Transponder IC with a Sensitivity of &#x2212;12 Dbm

An Ultra Low Power ASK Demodulator for Passive UHF RFID Tag

A 6.93 µW wake-up circuit for active RFID Tags

A Low Power Signal-Detector Design and Its Implementation for RFID Systems

Analysis and Design of a Multi-Mode Wake-Up Receiver Based on Direct Envelope Detection in Wireless Sensor Networks

A Low-Power RF Front-End of Passive UHF RFID Transponders

A semi-passive UHF RFID tag with on-chip temperature sensor

A Low Power Low Cost Fully Integrated Uhf Rfid Reader With 17.6dbm Output P1db In 0.18 Mu M Cmos Process

A Current-Mode Voltage Regulator with an Embedded Sub-Threshold Reference for a Passive UHF RFID Transponder