Effects of 2-D transition metal carbide Ti2CTx on properties of epoxy composites

Heng Zhang,Libo Wang,Aiguo Zhou,Changjie Shen,Yahui Dai,Fanfan Liu,Jinfeng Chen,Ping Li,Qianku Hu
DOI: https://doi.org/10.1039/c6ra14560d
IF: 4.036
2016-01-01
RSC Advances
Abstract:Here, 2-D nanostructured Ti2CTx was successfully synthesized by selectively exfoliating the Ti2AlC MAX phase via a liquid etching technique. Investigated as a promising and functional reinforcement additive, 2-D Ti2CTx nanosheets were dispersed into an epoxy matrix evenly at different mass percentages to obtain self-lubricating and anti-friction Ti2CTx/epoxy resin (EP) nanocomposites with high toughness and low creep strain by in situ intercalative polymerization. The phase structure and morphology of Ti2CTx and Ti2CTx/EP nanocomposites were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Subsequently, this work studied the effect of Ti2CTx on the EP matrix in terms of fracture surface morphology, glass transition temperature (T-g), storage modulus (E-s), thermal stability, mechanical properties and dry sliding anti-friction properties. The results show that Ti2CTx interlayers were intercalated and exfoliated with EP molecular chains and intertwined with each other, which produced a greater interfacial area between the inorganic additive and the polymer matrix, resulting in the formation of Ti2CTx/EP nanocomposites without adverse structural defects. With the addition of an appropriate mass fraction of Ti2CTx, the fracture toughness and flexural strength of EP composites reached 17.8 kJ m(-2) and 98 MPa, which represented increases of 76% and 66%, respectively, compared with those of pure EP. In addition, increases in Tg and Es of 15% and 38% were achieved, respectively, relative to those of pure EP when the concentration of Ti2CTx was 2.0 wt%. Moreover, tribological analysis indicated that there was a great improvement in anti-friction properties and the morphology of worn surfaces of the nanocomposites appeared to be smoother than that of pure EP, which implied the transformation of fatigue and abrasion wear into adhesion wear. This work is of great significance in that novel 2-D transition metal carbide crystals were employed to fill and modify a thermoset polymer resin and enhance its toughness and strength and, as a self-lubricating additive, enabled a great breakthrough in the anti-friction properties of polymer-matrix composites.
What problem does this paper attempt to address?