Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

CO-Mediated Deactivation Mechanism of SiO2-Supported Copper Catalysts During Dimethyl Oxalate Hydrogenation to Ethylene Glycol

Theoretical Investigation on the CO2 Hydrogenation to Methanol Mechanism at Electron-Rich Active Interface over Cu/Ga-Ti-Al-O Catalyst

Stabilizing Cu0/Cu2+ Interface by Hydroxy-Rich Amorphous SiO2 for Enhanced Electrocatalytic CO2 Reduction to Ethylene

Role of the Cu dopant in the textural and catalytic features of the Co/ZnO catalyst for dimethyl oxalate selective hydrogenation

Ultra-stable Cu-based catalyst for dimethyl oxalate hydrogenation to ethylene glycol

Enhanced catalytic stability of Cu-based catalyst for dimethyl oxalate hydrogenation

Efficient Tuning of Surface Copper Species of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Solvent Feedstock Effect: the Insights into the Deactivation Mechanism of Cu/SiO2 Catalysts for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol.

The Role of Cu1-O3 Species in Single-Atom Cu Catalyst for Directional Methanol Synthesis from CO2 Hydrogenation

Enhanced Catalytic Performance for SiO2–TiO2 Binary Oxide Supported Cu-based Catalyst in the Hydrogenation of Dimethyloxalate

Highly stable Cu catalyst embedded in N-doped carbon microsphere for hydrogenation of dimethyl oxalate to methyl glycolate

The Nature of Active Copper Species in Cu-HMS Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol: New Insights on the Synergetic Effect Between Cu0 and Cu+

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Facile preparation of efficient Cu-SiO 2 catalysts using a polyhydroxy molecular template to regulate surface copper species for dimethyl oxalate hydrogenation

Cu/SiO2 catalysts prepared by different methods for hydrogenolysis of dimethyl oxalate to ethylene glycol

Optimizing CO 2 Hydrogenation to DME through Tailored Interfacial Interactions: Weakening Synergy in CuZnZr and Al-Modified SBA-15 Catalysts

Mechanism of Methanol Synthesis from CO2 Hydrogenation over Cu/γ-Al2O3 Interface: Influences of Surface Hydroxylation

Superior silicon-free Cu catalyst for dimethyl oxalate hydrogenation: Exploring interaction between Cu and pyridinic-N-rich ultrathin carbon

Perspectives on the Active Sites and Catalyst Design for the Hydrogenation of Dimethyl Oxalate

Catalytic Performance and Texture of Teos Based Cu/Sio2 Catalysts for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Selective Hydrogenation of CO2 into Dimethyl Ether over Hydrophobic and Gallium-Modified Copper Catalysts