Electropulsing of Low-Density Duplex Steel for Strengthening and Ductilization by Microstructural Refinement
Rajavarapu Pavan Kumar,N.C. Santhi Srinivas,R.K. Pandey,R Manna
DOI: https://doi.org/10.1016/j.jmatprotec.2024.118423
IF: 6.3
2024-05-13
Journal of Materials Processing Technology
Abstract:The present investigation finds the effect of electropulsing treatment on the mechanisms of refining and reprecipitation of ordered L2 0 structure (B2) and its impact on tensile properties of low-density duplex steel of Fe-18Mn-10.5Al-1C-6Ni composition. The selected composition without manganese is melted at 1600°C by induction heating in a vacuum but Mn is added into the melt at 1560°C, in the argon atmosphere to reduce the loss. The melt is cast into a plate form in a copper mold. The cast steel is homogenized, hot rolled, and annealed (PD1-A sample) to get elongated bands, spheroids, and platelets of B2 phase with an austenitic matrix which results in a yield strength of 1015 MPa, and tensile strength of 1285 MPa with a plastic elongation of 16.3%. Electropulsing partially dissolves the B2 phase at a temperature much lower than the equilibrium solvus by reducing barrier energy because of electron wind. As a result, the sizes of bands and spheroids are reduced, and platelets are disintegrated. Electron wind force deforms coarse precipitates, and fragments as well as spheroidized it. Electropulsing of annealed steel (PD1-AE) mobilizes dislocations, and recovers it in B2, but induces localized recrystallization of austenite. At a later time of the signal, the temperature rapidly falls and the matrix becomes supersaturated but electropulsing accelerates low-temperature precipitation of the B2 phase. Therefore, electropulsing can be adopted as a fast manufacturing process to dissolve, deform, fragment, spheroidize and reprecipitate high temperature phase at much lower temperature by dominant athermal effect of electron wind energy over thermal effect. Electropulsing also induces recovery and recrystallization at a relatively low temperature and reduces defect density. Reduction in the overall size of B2 and its distribution towards better uniformity provided an increased yield strength of 1077 MPa, tensile strength of 1355 MPa, and a plastic elongation of 21.6%. The selected duplex low-density steel follows two-stage work hardening of Ludwigson model with an additional stage of dynamic recovery. Fractography analysis confirms that both samples show mixed modes of ductile and brittle fracture, with an increase in size and area percentage of dimples.
materials science, multidisciplinary,engineering, manufacturing, industrial