Abstract:Bayer red mud accounts for the largest proportion of solid waste produced in the non-ferrous metallurgy industry and is usually handled by stockpiling because of its high alkalinity. The calcification–carbonation method (CCM) was proposed to extract alumina and sodium oxide from red mud using a fully hydrometallurgical process in order to scale the valuable utilization of Bayer red mud. In this study, a modified CCM was applied, using calcium aluminate hydrate as the calcium source to recover alumina from a low-NaOH-concentration digested solution. Thermodynamic analysis revealed that the stable product of the calcification process was hydrogarnet with a high silicon saturation coefficient (x, 3CaO·Al2O3·xSiO2·6-2xH2O), and a higher reaction temperature was beneficial for the formation of hydrogarnet with a high silicon saturation coefficient. Experimental results indicated that: (1) the calcification temperature was the most important determinant of the coefficient x of the hydrogarnet, which varied from 0.35 to 0.98 over a temperature range of 60–280 °C; (2) the x value and Na mass content in the calcified slag were 0.98 and 0.35%, respectively, under calcification conditions with an NaOH concentration of 200 g/L, a temperature of 260 °C, and a C/S of 2.5:1; (3) the Na mass content and A/S decreased to 0.03% and 0.52, respectively, in the new red mud structure due to the carbonation and digestion process. The Na mass content in the new red mud structure satisfies the raw material requirements for the cement industry, and approximately 74% of the alumina in the Bayer red mud was recovered by the CCM treatment. The primary phase in the new red mud structure was CaCO3, which can be used for preparing cement or other building materials.

Sulfur Fixation By Chemically Modified Red Mud Samples Containing Inorganic Additives: A Parametric Study

Optimization of the treatment of red mud with sulfur dioxide

Sulfur Removal by Adding Aluminum in the Bayer Process of High-Sulfur Bauxite

Sulfur Removal with Active Carbon Supplementation in Digestion Process

Experiments on effect of red mud-based slag on distribution of sulfur in liquid iron

Effect of Red Mud Additive on the Combustion Performance of Lignite and Sulfur Fixation Behaviors

Removal of Sulfur by Adding Zinc During the Digestion Process of High-Sulfur Bauxite

Mechanism of Red Mud Combined with Fenton'S Reagent in Sewage Sludge Conditioning

A Case Study of Producing Alumina from High-Sulfur Diasporic Bauxite: Sulfur-Containing Desilication Products and Pyrite in Red Mud

Utilization of Bayer red mud by a calcification–carbonation method using calcium aluminate hydrate as a calcium source

Calcification- Carbonation Method for Comprehensive Utilization of Low-grade Bauxite and Bayer Red Mud

Study on using red mud to control phosphorus release in sediment

Red mud with enhanced dealkalization performance by supercritical water technology for efficient SO 2 capture

Research of Leaching Alumina and Iron Oxide from Bayer Red Mud

Settling properties and utilization of red mud produced in Bayer process with an excessive addition lime

Direct Calcification–Carbonation Method for Processing of Bayer Process Red Mud

Study on the effect of sodium removal from citric acid pretreated red mud on the physical properties of red mud

Recovery of Alumina and Ferric Oxide from Bayer Red Mud Rich in Iron by Reduction Sintering

Reduction of Red Mud Discharge by Reductive Bayer Digestion: A Comparative Study and Industrial Validation

Transformation and Characterization of Cement Clinker Prepared from New Structured Red Mud by Sintering

Utilization of Red Mud and Pb/Zn Smelter Waste for the Synthesis of a Red Mud-Based Cementitious Material