Abstract:HISs have recently shown the ability to support leaky waves, and to excite plasmonic and HIS resonance frequency modes for use as an antenna. In this paper, we analyzed, designed, and fabricated a TMA by directly feeding edge-located HIS cells through a microstrip feeding network. In contrast to other metasurface antennas that necessitate an external antenna to excite metasurfaces, our approach is inspired by the TMA design methodology that directly feeds the HIS cells rather than using it as a reflector. We developed a circuit model for the proposed structure and compared the results with those obtained from full-wave simulations. In addition, our further objective was to simplify the structure based on the working principle of the proposed antenna. This objective was achieved by converting square patches into parallel strip lines, leading to an aperture efficiency of 0.77. This simplification also creates additional space to explore various resonant patterns on the top surface and the feeding network on the bottom surface of the TMA. Full-wave simulation results indicate that, despite the compact dimensions of the proposed array with 64 electrically small patch resonators (1.84{\lambda}*1.84{\lambda}*0.032{\lambda}, where{\lambda}is the free space wavelength at 6.0 GHz), it achieves a realized gain, HPBW of about 15.1 dBi and 28° respectively at 6 GHz. Finally, we constructed a prototype and conducted measurements to validate the design. Measured results demonstrate good agreement with simulation ones with a gain of about 13.5 (+-0.5) dBi and a HPBW of 27° at 6 GHz. The proposed TMA is scaled to fit within the required dimensions for smart handheld devices at higher frequencies, while maintaining high gain capability. The design s scalability, single-feed, and compact footprint make it optimal for diverse wireless communication systems, such as car to car communications.

A novel antenna using high impedance surface resonance for THz imaging and sensing

A Design of Tunable High-Impedance Surface (HIS) Based on Hybrid Metal-Graphene Structure

A Novel Dual-Frequency Terahertz Antenna in Standard Cmos Technology

Photonic THz InISAR for 3D Positioning with High Resolution

Polarization Multiplexing Multichannel High-Q Terahertz Sensing System

Applications of High Impedance Surfaces for Surface Wave Elimination

Analysis, Design, and Fabrication of a High-Gain Low-Profile Metasurface Antenna Using Direct Feeding of Sievenpiper s HIS

A 94 GHz Slot Array Fed by a WR10 Interface

Resonant Polysilicon Antenna for Terahertz Detection

Design of a plasmonic-organic hybrid slot waveguide integrated with a bowtie-antenna for terahertz wave detection

Generating terahertz signals in 65nm CMOS with negative-resistance resonator boosting and selective harmonic suppression

Dual-frequency CMOS Terahertz Detector with Silicon-Based Plasmonic Antenna

1THz one-sided directional slot antenna on a chip connected with InAs HEMT

A high-performance sub-THz planar antenna array for THz sensing and imaging applications

Design of High-Gain Antenna Arrays for Terahertz Applications

Performance characterization of a self-made terahertz photoconductive antenna

High performance antenna-on-chip inspired by SIW and metasurface technologies for THz band operation

Modal analysis and higher order mode suppression of a high impedance surface-based bowtie antenna

Compact High-Gain Si-Imprinted THz Antenna for Ultrahigh Speed Wireless Communications

Shielded cantilever with on-chip interferometer circuit for THz scanning probe impedance microscopy

Si-based Multiband Terahertz Antennas