Abstract:Longitudinal crack defects are a frequent occurrence on the surface of thin slabs during the high-speed continuous casting process. Therefore, this study undertakes a detailed analysis of the solidification characteristics of hyper-peritectic steel thin slabs. By establishing a three-dimensional heat transfer numerical model of the thin slab, the formation mechanism of longitudinal cracks caused by uneven growth of the initial shell is determined. Based on the mechanism of longitudinal crack formation, by adjusting the performance parameters of the mold flux, the contradiction between the heat transfer control and lubrication improvement of the mold flux is fully coordinated, further reducing the incidence of longitudinal cracks on the surface of the casting thin slab. The results show that, using the optimized mold flux, the basicity increases from 1.60 to 1.68, the F- mass fraction increases from 10.67% to 11.22%, the Na2O mass fraction increases from 4.35% to 5.28%, the Li2O mass fraction increases from 0.68% to 0.75%, and the carbon mass fraction reduces from 10.86% to 10.47%. The crystallization performance and rheological properties of the mold flux significantly improve, reducing the heat transfer performance while ensuring the lubrication ability of the molten slag. After optimizing the mold flux, a surface detection system was used to statistically analyze the longitudinal cracks on the surface of the casting thin slab. The proportion of longitudinal cracks (crack length/steel coil length, where each coil produced is about 32 m long) on the surface of the thin slab decreases from 0.056% to 0.031%, and the surface quality of the thin slab significantly improves.

Analysis and Control of Central Cracks in the Bloom Continuous Casting of Microalloy 49mnvs3 Steel

Analysis and control of surface cracks in a B-bearing continuous casting blooms

Analysis of Internal Cracks in High Carbon Casting Bloom Induced by Soft Reduction Process and Its Improvement Using Numerical Simulations and Industrial Experiments

Controlling Centre Segregation and Shrinkage Cavities Without Internal Crack in As-Cast Bloom of Steel GCr15 Induced by Soft Reduction Technologies

A review of research on central crack in continuous casting strand

Alleviation Of Internal Cracks In Continuous Casting Bloom Of Steel 100cr6 Induced By Soft Reduction Process

Homogenization Path Based on 250 mm × 280 mm Bloom under Mixed Light and Heavy Presses: Simulation and Industrial Studies

High-efficiency continuous casting of GCr15 bearing steel bloom based on cooperative control technique of complex electromagnetic stirring and soft reduction

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Analysis of Thermomechanical Behavior in Continuous Bloom Casting Mold

INFLUENCE OF INTERNAL CRACKING ON CARBIDE PRECIPITATION IN CONTINUOUS CASTING BLOOM INDUCED BY SOFT REDUCTION TECHNOLOGY AND THE RESULTING SEGREGATED BAND IN HOT-ROLLED WIRE RODS

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

Cracking and segregation in high-alloy steel 0.4C1.5Mn2Cr0.35Mo1.5Ni produced by thick continuous casting

A Method to Control the Transverse Corner Cracks on a Continuous Casting Slab by Combining Microstructure Analysis with Numerical Simulation of the Slab Temperature Field

Analysis of Internal Cracks in Continuous Casting Slabs with Soft Reduction

Some Aspects of Continuous Casting of Low Carbon Microalloyed Steels with Niobium and Titanium

Prediction and Analysis on Formation of Internal Cracks in Continuously Cast Slabs by Mathematical Models.

Research Status of High-Manganese High-Aluminum Steel and Key Points of Continuous Casting

Numerical Simulation of Central Shrinkage Crack Formation in a 234-T Steel Ingot

Optimization for Secondary Cooling Parameters in Continuous Casting of High Carbon Chromium Bearing Steel

Propagation form of internal cracks induced by continuous casting soft reduction and control strategy for internal quality