Abstract:Integrating CO2 capture and electrochemical conversion has been proposed as a strategy to reduce the net energy required for CO2 regeneration in traditional CO2 capture and conversion schemes and can be coupled with carbon-free renewable electricity. Polyethylenimine (PEI)-based materials have been previously studied as CO2 capture materials and can be integrated in these reactive capture processes. PEI-based electrolytes have been found to significantly increase the CO2 loading, and impact selectivity and rate of product formation when compared to the conventional aqueous electrolytes. However, the influence of these materials at the catalyst-electrode interface is currently not well understood. In this study, PEI-based electrolytes were prepared and their impact on the morphology of a silver electrode performing electrochemical CO2 reduction (CO2R) was studied using in situ electrochemical atomic force microscopy (EC-AFM). The presence of PEI on the electrode surface could be distinguished based on nanomechanical properties (DMT modulus), and changes were observed as negative polarization was applied, revealing a reorganization of the PEI chains due to electrostatic interactions. These changes were impacted by the electrolyte composition, including the addition of supporting electrolyte KHCO3 salt, as well as CO2 captured by the PEI-based electrolyte, which minimized the change in surface mechanical properties and degree of PEI alignment on the electrode surface. The changes in surface mechanical properties were also dependent on the PEI polymer length, with higher molecular weight PEI showing different reconfiguration than the shorter polymer brushes. The study highlights that the choice of polymer material, the electrolyte composition, and CO2 captured impact the near-electrode environment, which has implications for CO2R, and presents EC-AFM as a new tool that can be used to probe the dynamic behavior of these interfaces during electrocatalysis.

Electrochemical Reduction of Gaseous CO2 with a Catechol and Polyethyleneimine Co-Deposited Polypropylene Membrane

Directly‐Deposited Ultrathin Solid Polymer Electrolyte for Enhanced CO2 Electrolysis

Polymer‐Supported Liquid Layer Electrolyzer Enabled Electrochemical CO2 Reduction to CO with High Energy Efficiency

Intrinsically Conductive and Cu-Functionalized Polymer-Composite Membranes as Gas Diffusion Electrodes for CO2 Electroreduction

Carbon‐Efficient CO2 Electrolysis to Ethylene with Nanoporous Hydrophobic Copper

Effect of cationic and anionic solid polymer electrolyte on direct electrochemical reduction of gaseous CO2 to fuel

Boosting Electrochemical CO2 Reduction to CO by Regulating the Porous Structure of Carbon Membrane

Precise Site-Hydrophobicity Modulation for Boosting High-Performance CO 2 Electroreduction

Direct Membrane Deposition for CO 2 Electrolysis

Polymer Modification Strategy to Modulate Reaction Microenvironment for Enhanced CO2 Electroreduction to Ethylene

Imidazolium Group Prompted Alkaline Anion-Exchange Membrane with High Performance for Efficient Electrochemical CO 2 Conversion

Continuous Carbon Dioxide Electroreduction to Concentrated Multi-carbon Products Using a Membrane Electrode Assembly

Hydrophobized electrospun nanofibers of hierarchical porosity as the integral gas diffusion electrode for full-pH CO2 electroreduction in membrane electrode assemblies

Trilayer Polymer Electrolytes Enable Carbon‐efficient CO2 to Multicarbon Product Conversion in Alkaline Electrolyzers

Graphene Oxide Prompted Double-Crosslinked Poly(Vinyl Alcohol)/Poly(Diallyldimethylammonium Chloride) Anion-Exchange Membrane for Superior Co2 Electrochemical Reduction

Gas-phase CO 2 electrolysis using carbon-derived bismuth nanospheres on porous nickel foam gas diffusion electrode

Efficient Electrocatalytic Reduction of CO2 by Nitrogen-Doped Nanoporous Carbon-Carbon Nanotube Membranes - A Step Towards the Electrochemical CO2 Refinery

Improving the efficiency of CO2 electrolysis by using a bipolar membrane with a weak-acid cation exchange layer

High-Rate and Efficient Ethylene Electrosynthesis Using a Catalyst/Promoter/Transport Layer

Self-supporting BiCu/carbon hybrid nanofiber membrane promotes efficient CO2 electroreduction to formate

Electrolyte-Electrocatalyst Interfacial Effects of Polymeric Materials for Tandem CO2 Capture and Conversion Elucidated Using In Situ Electrochemical AFM