Abstract:The slow kinetics of the oxygen reduction reaction (ORR) is one of the key obstacles for the widespread commercialization of polymer electrolyte membrane fuel cells (PEMFCs), which has been established as one of the zero-emission power sources for the future [1-4]. Pt and its alloys with transition metals are frequently used as electrocatalysts for the cathodic oxygen reduction. However, the high cost and low utilization of Pt of the state-of-the-art Pt catalysts continues to humper its broad application in PEMFCs. This can be resolved using the Pt monolayer catalysts having low Pt loading, high utilization efficiency, as well as high activity and durability [5, 6]. We recently showed that Pt monolayer shell deposited on Pd or PdAu alloy core has higher activity and stability than pure Pt electrocatalysts [6]. However, total Pt group metal content is still too high for practical application. As a non-Pt group metal, Au is a good candidate for the core material since it is stable under the oxidizing conditions of the ORR. However, the lack of interest in the Au@Pt core-shell catalysts can be attributed to two impeding effects on ORR activity, that are, the strong bonding of OH and O to Pt due to the up-shifts of d-band center for Pt on Au core induced mainly by the strain effects [7], and the blocking of active sites of Pt due to the Au segregation onto the Pt surface [6, 8]. In this contribution we are reporting on a novel Au@Pt core-shell catalyst with the low-coordinated surface sites doped by Ti oxide, e.g. vertex and edges, while Pt occupies the surface facets, Ti-Au@Pt (Fig. 1). Its mass (3.0 A mg –1 Pt ) and specific activities (1.32 mA cm –2 Pt ) are about 13 and 5 times higher than the corresponding activities of the commercial Pt/C catalyst (0.22 A mg –1 Pt and 0.254 mA cm –2 Pt ), respectively (Fig. 2). This mass activity is among the highest reported for the Pt based core-shell nanoparticles under similar testing conditions, while the durability tests show no activity loss after 10,000 potential cycles from 0.6 to 1.0 V (vs. RHE). By correlating electron energy-loss spectroscopy and X-ray photoelectron spectroscopy analyses with electrochemical measurements, we attribute the superior activity and durability of the new Ti-Au@Pt catalyst to its distinct microstructure. The enhanced ORR activity of Ti-Au@Pt/C compared to commercial Pt/C is due to a more effective hydrogenation of OH ad on its Pt surface than commercial Pt/C catalyst. This can be attributed to the repulsive interaction between the OH ad on Pt and the oxide species on a neighboring Ti. Improved durability can also be attributed to the presence of the Ti which prevents Au atoms from segregating onto the Pt surface and thus can largely retain the electrochemical surface area. This core-shell catalyst points to a new direction for the ORR and similar catalysts design and optimization. Acknowledgment Work at Brookhaven National Laboratory is supported by US Department of Energy, Division of Chemical Sciences, Geosciences and Biosciences Division, under the Contract No. DE-AC02-98CH10886. References 1. H. A. Gasteiger and N.M. Marković, Science , 324 , 48 (2009). 2. M. K. Debe, Nature , 486 , 43 (2012). 3. V. R. Stamenkovic, B. Fowler, B. S. Mun, G. Wang, P. N. Ross, C. A. Lucas, and N. M. Markovic, Science , 315 , 493 (2007). 4. P. Hernandez-Fernandez et al., Nature Chemistry , 6 , 732 (2014). 5. R. R. Adzic, Electrocatalysis , 3 , 163 (2012). 6. K. Sasaki, H. Naohara, Y. Choi, Y. Cai, W.-F. Chen, P. Liu and R. R. Adzic, Nature Communications , 3 , 1115 (2012). 7. J. Zhang, M.B. Vukmirovic, Y. Xu, M. Mavrikakis, and R.R. Adzic, Angew. Chem. Int. Ed. , 44 , 2132 (2005). 8. A.V. Ruban, H.L. Skriver, and J.K. Nørskov, Phys. Rev. B , 59 , 15990 (1999). Figure 1

Oxygen Reduction Kinetics on Pt Monolayer Shell Highly Affected by the Structure of Bimetallic Auni Cores

Shaped Pt-Ni Nanocrystals with an Ultrathin Pt-enriched Shell Derived from One-Pot Hydrothermal Synthesis As Active Electrocatalysts for Oxygen Reduction

Local Coordination and Ordering Engineering to Design Efficient Core-Shell Oxygen Reduction Catalysts

Platinum Monolayer on Au-Ni Nanoparticles Electrocatalysts for the Oxygen Reduction Reaction: The Effect of Au-Ni Nanostructures

Multimetallic AuPd@Pd@Pt Core-Interlayer-shell Icosahedral Electrocatalysts for Highly Efficient Oxygen Reduction Reaction

Tuning the catalytic activity of Ru@Pt core-shell nanoparticles for the oxygen reduction reaction by varying the shell thickness

Why Does Pt Shell Bearing Tensile Strain Still Have Superior Activity for the Oxygen Reduction Reaction?

Core@shell nanostructured Au-d@NimPtm for electrochemical oxygen reduction reaction: effect of the core size and shell thickness

Core–Shell Nanostructured Au@NimPt2 Electrocatalysts with Enhanced Activity and Durability for Oxygen Reduction Reaction

Octahedral Pd@Pt1.8Ni Core-Shell Nanocrystals with Ultrathin PtNi Alloy Shells As Active Catalysts for Oxygen Reduction Reaction.

Core@shell Sub-Ten-nanometer Noble Metal Nanoparticles with a Controllable Thin Pt Shell and Their Catalytic Activity Towards Oxygen Reduction

Core@shell nanostructured Au-<i>d</i>@Ni<sub>m</sub>Pt<sub>m</sub> for electrochemical oxygen reduction reaction: effect of the core size and shell thickness

Electrochemical Designing of Au/Pt Core Shell Nanoparticles as Nanostructured Catalyst with Tunable Activity for Oxygen Reduction

Increasing Stability and Activity of Core-Shell Catalysts by Preferential Segregation of Oxide on Edges and Vertexes: Oxygen Reduction on Ti-Au@Pt/C

One-Step Synthesized Pt-on-NiCo Nanostructures for Oxygen Reduction with High Activity and Long-Term Stability

Electrochemical Synthesis of Monodispersed and Highly Alloyed PtCo Nanoparticles with a Remarkable Durability Towards Oxygen Reduction Reaction

Active and Stable Pt-Ni Alloy Octahedra Catalyst for Oxygen Reduction via Near-Surface Atomical Engineering

Composition-Graded PdxNi1–x Nanospheres with Pt Monolayer Shells As High-Performance Electrocatalysts for Oxygen Reduction Reaction

A core–shell Pd1Ru1Ni2@Pt/C catalyst with a ternary alloy core and Pt monolayer: enhanced activity and stability towards the oxygen reduction reaction by the addition of Ni

Ni–Pd core–shell nanoparticles with Pt-like oxygen reduction electrocatalytic performance in both acidic and alkaline electrolytes

Origin of Oxygen Reduction Reaction Activity on “pt3co” Nanoparticles: Atomically Resolved Chemical Compositions and Structures