Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Direct Imaging Single Methanol Molecule Photocatalysis on Titania

Temperature- and Coverage-Dependent Kinetics of Photocatalytic Reaction of Methanol on TiO2 (110)-(1 × 1) Surface

Surface Reconstruction-Induced Photocatalytic Methanol Reduction Reaction on a Rutile TiO2(001) Surface

Site-Specific Photocatalytic Splitting of Methanol on Tio2(110)

In Situ Studies on Temperature-Dependent Photocatalytic Reactions of Methanol on TiO2(110)

Active Species in Photocatalytic Reactions of Methanol on TiO2(110) Identified by Surface Sum Frequency Generation Vibrational Spectroscopy

Photocatalytic Cross-Coupling Of Methanol And Formaldehyde On A Rutile Tio2(110) Surface

Identifying the Site-Dependent Photoactivity of Anatase TiO2(001)-(1×4) Surface

One-Step Synthesis Of Bifunctional Tio2 Catalysts And Their Photocatalytic Activity

Sequential Photo-Oxidation of Methanol to Methyl Formate on TiO2(110).

Origin of the Adsorption-State-Dependent Photoactivity of Methanol on TiO 2 (110)

Adsorption Structure-Activity Correlation in the Photocatalytic Chemistry of Methanol and Water on TiO 2 (110)

Visualizing Elementary Reactions of Methanol by Electrons and Holes on TiO2(110) Surface

Structures and Stability of Adsorbed Methanol on TiO2(110) Surface Studied by Ab Initio Thermodynamics and Kinetic Monte Carlo Simulation

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Mechanistic Understanding of the Thermal-Assisted Photocatalytic Oxidation of Methanol-to-Formaldehyde with Water Vapor over Pt/SrTiO3

Multi-scaling study of adsorption and desorption of methanol on TiO2(110) surface

Level alignment of a prototypical photocatalytic system: Methanol on TiO2(110)

Site Sensitivity Of Interfacial Charge Transfer And Photocatalytic Efficiency In Photocatalysis: Methanol Oxidation On Anatase Tio2 Nanocrystals

Observation of Photocatalytic Dissociation of Water on Terminal Ti Sites of TiO2(110)-1 × 1 Surface

Theoretical Study of the Molecular and Electronic Structure of Methanol on a TiO2(110) Surface