Abstract:The intrinsic behavior of photogenerated charges and reactions with chemicals are key for a photocatalytic process. To observe these basic steps is of great importance. Here we present a reliable and robust system to monitor these basic steps in powder photocatalysts, and more importantly to elucidate the key issue in photocatalytic methane conversion over the benchmark catalyst TiO2. Under constant excitation, the absorption signal across the NIR region was demonstrated to be dominated by photoexcited electrons, the absorption of photoexcited holes increases toward shorter wavelengths in the visible region, and the overall shapes of the photoinduced absorption spectra obtained using the system demonstrated in the present work are consistent with widely accepted transient absorption results. Next, in situ measurements provide direct experimental evidence that the initial step of methane activation over TiO2 involves oxidation by photoexcited holes. It is calculated that 90 ± 6% of photoexcited electrons are scavenged by O2 (in dry air), 61 ± 9% of photoexcited holes are scavenged by methane (10% in argon), and a similar amount of photoexcited electrons can be scavenged by O2 even when the O2 concentration is reduced by a factor of 10. The present results suggest that O2 is much more easily activated in comparison to methane over anatase TiO2, which rationalizes the much higher methane/O2 ratio frequently used in practice in comparison to that required stoichiometrically for photocatalytic production of value-added chemicals via methane oxidation with oxygen. In addition, methanol (a preferable product of methane oxidation) is much more readily oxidized than methane over anatase TiO2.This article has not yet been cited by other publications.

Site Sensitivity Of Interfacial Charge Transfer And Photocatalytic Efficiency In Photocatalysis: Methanol Oxidation On Anatase Tio2 Nanocrystals

Identifying the Site-Dependent Photoactivity of Anatase TiO2(001)-(1×4) Surface

Origin of the Adsorption-State-Dependent Photoactivity of Methanol on TiO 2 (110)

Active Species in Photocatalytic Reactions of Methanol on TiO2(110) Identified by Surface Sum Frequency Generation Vibrational Spectroscopy

In Situ Studies on Temperature-Dependent Photocatalytic Reactions of Methanol on TiO2(110)

Spontaneous Bulk-Surface Charge Separation of TiO2-{001} Nanocrystals Leads to High Activity in Photocatalytic Methane Combustion

Spontaneous Bulk-Surface Charge Separation of TiO 2 -{001} Nanocrystals Leads to High Activity in Photocatalytic Methane Combustion

Adsorption Structure-Activity Correlation in the Photocatalytic Chemistry of Methanol and Water on TiO 2 (110)

In Situ Investigation of Charge Performance in Anatase TiO2 Powder for Methane Conversion by Vis–NIR Spectroscopy

In Situ Investigation of Charge Performance in Anatase TiO 2 Powder for Methane Conversion by Vis–NIR Spectroscopy

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Self-assembly and Photocatalysis of Mesoporous TiO 2 Nanocrystal Clusters

Surface Reconstruction-Induced Photocatalytic Methanol Reduction Reaction on a Rutile TiO2(001) Surface

Temperature- and Coverage-Dependent Kinetics of Photocatalytic Reaction of Methanol on TiO2 (110)-(1 × 1) Surface

Role of Ag Loading on the Concentration of Surface-Reaching Photoexcited Holes in TiO 2 Nanoparticles

Optimizing Nanoscale TiO2 for adsorption-enhanced photocatalytic degradation of low-concentration air pollutants

Active Sites for Adsorption and Reaction of Molecules on Rutile Tio2(110) and Anatase Tio2(001) Surfaces

Site-Specific Photocatalytic Splitting of Methanol on Tio2(110)

Roles of Crystal Surface in Pt-Loaded Titania for Photocatalytic Conversion of Organic Pollutants: A First-Principle Theoretical Calculation

Multi-scaling study of adsorption and desorption of methanol on TiO2(110) surface

Photocatalytic H2 production from methanol aqueous solution over titania nanoparticles with mesostructures