Abstract:Introduction: In this study, the spatial bending vibration of macro- and/or micro-scale cantilevered fluid-conveying pipes is investigated through finite dimensional analysis. Methods: Firstly, the Galerkin method is employed to discretize the partial differential equations of motion of the system into a system of ordinary differential equations. Then, the projection method based on center manifold-normal form theory is adopted to derive the coefficient formula that determines the pipe's nonlinear dynamic behaviors, i.e., the change rate of the real part of the critical eigenvalue with respect to the flow velocity and the nonlinear resonance term, thereby obtaining reduced-order equations. Compared to previous studies that relied on the numerical solution of ordinary differential equations to determine the existence and stability of periodic motion, this paper concludes the existence and stability of periodic motion by utilizing the coefficients of the Galerkin discretized equations and the reduced-order equations, significantly saving time in determining the dynamic properties of pipes. Results and discussion: Subsequently, by investigating the reduced-order equations under specific parameters, the existence and stability of the two types of periodic motion of the pipe are studied. For macro pipes, the truncated mode numbers are set incrementally to calculate the coefficients of the reduced-order equations, investigate the distribution of the stability of the two types of periodic motions with the mass ratio, and carry out a longitudinal comparison (i.e., the comparison between the results obtained under different truncated mode numbers) as well as a horizontal comparison (i.e., the comparison of results between the finite dimensional analysis and the infinite dimensional analysis). It is found that the reasonable truncated mode number required to study this type of system is 15. Previous studies primarily focused on the convergence of frequency and amplitude when determining the truncated mode numbers. On this basis, our study further examines the convergence of motion forms with respect to the truncated mode numbers. Finally, based on the Galerkin discretization equations of 15 modes, the distribution of the stability of two types of the periodic motion of micro pipes with the mass ratio is analyzed. For macro- and micro-scale pipes, when the truncated mode number is 15, the error between the finite dimensional analysis results and the infinite dimensional analysis results is calculated to be about 7%. The above results are verified by obtaining the numerical solution to Galerkin discretization equations.

Modal Analysis of the Gyroscopic Continua: Comparison of Continuous and Discretized Models

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

Distributed Modal Identification and Vibration Control of Continua: Piezoelectric Finite Element Formulation and Analysis

Regular and compound behavior of a pendulum system in a magnetic field

Characterization of Modal Frequencies and Orientation of Axisymmetric Resonators in Coriolis Vibratory Gyroscopes

On Mode Orthogonality Of Complex Structures

Modal truncation method for continuum structures based on matrix norm: modal perturbation method

Modal-Decomposition-Dependent State-Space Modeling and Modal Analysis of a Rigid-Flexible, Coupled, Multifreedom Motion System: Theory and Experiment

Existence/nonexistence of instability regions in a parametrically excited linear gyroscopic system

Modal Dynamic Modelling and Experimental Validation of a Curved Extensible Continuum Manipulator

Semi-analytical solutions for forced and free vibration of damped fluid-conveying pipe systems based on complex modal superposition method

On Normal Modes of Vibrating 1-D Mechanical Systems with Discontinuous Properties

Study on Repeated-Root Modes in Substructure Modal Composition Analysis

Periodic motion of macro- and/or micro-scale cantilevered fluid-conveying pipes with O(2) symmetry: a finite dimensional analysis

Model Reduction of a Continuous System with Friction-Induced Vibration Considering Separation and Re-Contact

Nonlinear Dynamical System Model for Drive Mode Amplitude Instabilities in MEMS Gyroscopes

Self-organized Hydrodynamics in an Annular Domain: Modal Analysis and Nonlinear Effects

Quasi-periodic motions in a special class of dynamical equations with dissipative effects: a pair of detection methods

Modal Dynamics and Analysis of a Vertical Stretch-Retractable Continuum Manipulator with Large Deflection

A scaled derivative-based DMDc method for modelling multiple-input multiple-output mechanical systems

EXTRACTION OF GLOBAL MODE FUNCTIONS AND CONSTRUCTION OF STATE SPACE MODEL FOR A COMPOSITE FLEXIBLE STRUCTURE