Abstract:Recently, many studies have reported the ultralow friction coefficient of sliding friction between rigid solid surfaces in aqueous lubrication. A running-in process that goes through high-friction and friction-decreasing regions to a stable ultralow friction region is often required. However, the role of the friction-decreasing region is often ascribed to tribofilm formation in which complexity hindered the quantitative description of the running-in process and the prediction of its subsequent lubrication state. In this work, the frictional energy ( Ef) dissipated in the running-in process of a poly(oligo(ethylene glycol) methyl ether acrylate) aqueous lubrication was related to the wear of solid surfaces under different conditions and lubrication states. Experimental results indicated that the high-friction region was in a boundary lubrication state, contributed to most of the wear, and significantly reduced the contact pressure, whereas the friction-decreasing region was in a mixed lubrication state, contributed only to the slight and slow removal of materials, and slightly reduced the contact pressure. Therefore, by establishing relationships among the wear scar diameter, Ef, and the Stribeck curve of the tribological system, the subsequent lubrication state after a running-in process under various working loads and sliding speeds could be quantitatively predicted. The running-in experiments with different aqueous lubrication systems showed good agreement with the prediction of this method. This investigation provides an effective method for the wear and lubrication state prediction after a running-in process, further proving the importance of the Stribeck curve for a lubrication system. This study may also have important implications for the strategy design of the running-in process in various industrial applications.

Investigation of running-in process in water-based lubrication aimed at achieving super-low friction

Investigation of the running-in process of silicon nitride sliding in aqueous solutions of ethylene glycol

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

Investigation of Ultra-Low Friction Between Self-Mated Si3n4 in Water after Running-In

Friction and Wear Properties of Si3N4 and SiC Used for Water-Lubricated Sliding Bearings

Tribological Characteristics of Silicon Nitride-chilled Cast Iron with Oil-less Lubrication

Effect of Running-In Conditions on the Super Low EHD Sliding Friction of Si3N4 Ball and WC Plate in Glycerol–Water Solution

Hydrodynamic Effect on the Superlubricity of Phosphoric Acid Between Ceramic and Sapphire

Superlubricity Achieved With Mixtures Of Acids And Glycerol

Achievement of Liquid Superlubricity of Silicone Oil by Running-in with Hydrogen Ions

Influence of silica nanoparticles on running-in performance of aqueous lubricated Si3N4 ceramics

Tribochemistry and Superlubricity Induced by Hydrogen Ions

On Lubrication States after a Running-In Process in Aqueous Lubrication.

Investigation of the Running-in Process and Friction Coefficient under the Lubrication of Ionic Liquid/water Mixture

Ni/Si3N4 composite coatings and their water lubrication behaviors

Investigations of the Superlubricity of Sapphire Against Ruby under Phosphoric Acid Lubrication

Superlubricity of Si 3 N 4 sliding against SiO 2 under linear contact conditions in phosphoric acid solutions

Effects of Abrasive Particles on Liquid Superlubricity and Mechanisms for Their Removal

Ultra-Low Friction Achieved by Diluted Lactic Acid Solutions

Superlubrication obtained with mixtures of hydrated ions and polyethylene glycol solutions in the mixed and hydrodynamic lubrication regimes

Investigation of the Running-in Process in Photoinduced Superlubricity