Abstract:Vitrification is a promising treatment for municipal solid waste incineration fly ash (MSWI-FA); however, high energy consumption due to the high MSWI-FA fusion temperature limits the development and application of this technique. In this study, fine slag ash (FSA) derived from coal gasification and coal gangue ash (CGA) were mixed with MSWI-FA to reduce the ash fusion temperature. The transformation of minerals in ash during thermal treatment was examined via X-ray diffraction and thermodynamic equilibrium calculations. The ash flow behaviour was observed using a thermal platform microscope, and the silicate structure was quantified using Raman spectra. The co-melting mechanisms for the mixed ash were systematically investigated. Results indicate that the flow temperature (FT) of the mixed ash exhibited an initial decrease and subsequent increase as a function of the addition ratio of FSA or CGA. Lowest ash FT of 1215 °C and 1223 °C were recorded for addition of 50% FSA and 50% CGA, respectively; further, these temperatures were lowered by > 285 °C and >277 °C respectively, relative to FT of the MSWI-FA. The transformation of minerals and silicate structure during mixed ash heating was responsible for the variation in the ash fusion temperature. CaO in MSWI-FA tended to react with mullite, quartz and haematite in FSA and CGA, forming minerals such as anorthite, gehlenite, and andradite with relatively low melting points. The addition of FSA or CGA caused changes in the silicate network structure of the mixed ash. In particular, 50% FSA incorporation caused the transformation of Q4 and Q3 to Q2, whereas 50% CGA introduction resulted in the conversion of Q4 and Q2 into Q3 and Q1 + Q0, respectively. The silicate network depolymerised, causing reduction in the ash fusion temperature and increasing the melting rate.

Fusion characteristics in c o-combustion of coal with industrial and municipal sludge

The Melting and Transformation Characteristics of Minerals During Co-Combustion of Coal with Different Sludges

High-Temperature Ash Melting and Fluidity Behavior upon the Cocombustion of Sewage Sludge and Coal

Mechanism of Na2O/CaO Ratio Affecting Ash Fusing Characteristics During Ash Deposition and Slagging in Municipal Solid Waste Incinerator

Sludge Acts As a Catalyst for Coal During the Co-Combustion Process Investigated by Thermogravimetric Analysis

Effecting mechanisms of iron-rich sludge on ash fusion characteristics of coal with high ash fusion temperature under reducing atmosphere

Thermochemical and Toxic Element Behavior during Co-Combustion of Coal and Municipal Sludge

Understanding Ash Sintering Variation Behaviors of Low-Rank Coals with Municipal Sludge Addition Based on Mineral Interactions

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Co-Combustion Characteristics of Municipal Sewage Sludge and Coal in a Lab-Scale Fluidized Bed Furnace

Co-melting mechanisms for municipal solid waste incineration fly ash with fine slag from coal gasification and coal gangue

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Study on the Coal Ash Fusibility During Blending Coal Combusition

Study on characterization of ash from co-combustion of coal with municipal solid waste

Study on Coal Ash Fusion Characteristics with TG-DSC Method

Combustion Effects and Emission Characteristics of SO2, CO, NOx and Heavy Metals During Co-Combustion of Coal and Dewatered Sludge

Co-combustion of sewage sludge and Zhundong coal: Effects of combustion conditions on gaseous pollutant emission and ash properties

Combustion characteristics of sewage sludge,coal water slurry and sludge-CWS mixtures by thermo gravimetric analysis

Study on Combustion Kinetics of Coal Water Slurry Prepared with Sewage Sludge

Ash formation characteristics in co-combusting coagulation sludge and Zhundong coal

Heavy metals behavior of co-combustion ash from sewage sludge and coal slime: Temperature and mixing ratio dependence, interactions and speciation