Abstract:Zhundong (ZD) coalfield has a large number of coal reserves. However, the severe fouling and slagging problems that occurred in ZD coal-fired utility boilers have seriously hindered the large-scale utilization of ZD coal. Deep understanding of the mineral transformation of ZD coal during combustion and its impact on fouling and slagging can provide technical support for fouling and slagging prevention in utility boilers. In this paper, a novel temperature and atmosphere controlling method was proposed to study ash deposition. Wucaiwan (WCW) coal ash samples in different atmospheres and temperatures were collected efficiently by the established single thermocouple high-temperature online microscope observation test rig. The influence of rapid heating and cooling on the mineral transformation of WCW coal ash samples was systematically investigated using XRD and SEM-EDS, respectively. The effects of SO2 in the flue gas on the mineral transformation and the sulphates generation of the coal ash were analysed by comparing the experimental results in oxidizing atmosphere and simulated flue gas atmosphere. The experimental results showed that the microscopic morphology, mineral and element conversion of coal ash samples during heating and cooling were quite different. Compared with oxidizing atmosphere, SO2 in the flue gas significantly increase the S content of ash at 600 degrees C 1200 degrees C and the amount of molten minerals on the quenched ash sample surface during cooling. These results indicate that SO2 can promote the sulfation reactions of alkali/alkaline earth metal (AAEM) on the quenched ash sample surface and restrain the decomposition of S-containing minerals in ash cooling. The investigation also reveals that the molten AAEM sulphate on the ash surface is mainly generated at 800 degrees C 900 degrees C. The present study not only provides the fundamental understandings of mineral transformation but also guides industrial applications to reduce the risk of ash deposition.

The Melting and Transformation Characteristics of Minerals During Co-Combustion of Coal with Different Sludges

Fusion characteristics in c o-combustion of coal with industrial and municipal sludge

Sludge Acts As a Catalyst for Coal During the Co-Combustion Process Investigated by Thermogravimetric Analysis

High-Temperature Ash Melting and Fluidity Behavior upon the Cocombustion of Sewage Sludge and Coal

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Thermochemical and Toxic Element Behavior during Co-Combustion of Coal and Municipal Sludge

Co-Firing Sludge in A Pulverized Coal-Fired Utility Boiler: Combustion Characteristics and Economic Impacts

Mineral Conversion of Coal-ash in Fusing Process and the Influence to Ash Fusion Point

Co-Combustion Characteristics of Municipal Sewage Sludge and Coal in a Lab-Scale Fluidized Bed Furnace

Understanding Ash Sintering Variation Behaviors of Low-Rank Coals with Municipal Sludge Addition Based on Mineral Interactions

Study on the Coal Ash Fusibility During Blending Coal Combusition

Mineral transformation during rapid heating and cooling of Zhundong coal ash

Co-combustion of sewage sludge and Zhundong coal: Effects of combustion conditions on gaseous pollutant emission and ash properties

Field Test and Numerical Simulation for Co-combustion of Sludge in a 100,MW Coal Fired Boiler

Experimental study of sludge disposal in a large coal-fired power plant

Combustion Effects and Emission Characteristics of SO2, CO, NOx and Heavy Metals During Co-Combustion of Coal and Dewatered Sludge

Mineral Conversion and Microstructure Change in the Melting Process of Shenmu Coal Ash

Analyses of Coal and Sewage Sludge Co-Combustion Using Coats-Redfern Model

Effecting mechanisms of iron-rich sludge on ash fusion characteristics of coal with high ash fusion temperature under reducing atmosphere

Ash formation characteristics in co-combusting coagulation sludge and Zhundong coal

Behavior of Slagging Deposits During Coal and Biomass Co-combustion in a 300 Kw Down-Fired Furnace