Abstract:In this article, an ultralow-power microelectromechanical system (MEMS) lead-free piezoelectric accelerometer digital system is developed. This proposed system is mainly composed of a MEMS lead-free piezoelectric accelerometer and a readout circuit with successive approximation register (SAR) analog-to-digital converter (ADC). In this work, ANSYS software is used to design the structure, and LZO (ZnO: 3 mol% Li) piezoelectric films are deposited by radio frequency (RF) sputtering method, and LZO-based MEMS lead-free piezoelectric accelerometers are developed with an effective bandwidth of about 600 Hz in the 3-dB range through the MEMS process. The proposed readout circuit achieves high linearity and ultralow power consumption by optimizing each operational amplifier (OPAMP) according to the linearity requirement of the whole system. The differential architecture is adopted to deal with the sensed signal for the purpose of reducing the common-mode noise. A proof-of-concept chip is implemented in a 0.18- $\mu \text{m}$ CMOS process. At 1.8-V supply voltage and 100-kS/s sampling rate, the ADC achieves a signal-to-noise-and-distortion ratio (SNDR) of 58.92 dB and a corresponding effective number of bits (ENOB) of 9.5 bits for an input at Nyquist frequency. The power consumption of the ADC is $2.18 \mu \text{W}$ , resulting a figure-of-merit (FoM) of 30.1 fJ/conversion step. Combining with the piezoelectric accelerometer, the accelerometer system can achieve 600-Hz bandwidth with a 142-mV/ ${g}$ sensitivity and the linearity is 0.9998. Finally, this system is applied to the unmanned aerial vehicle to monitor the motor health status and successfully judge whether the motor of the unmanned aerial vehicle is abnormal.

Development of a Micro Test System for Monitoring Structural Vibration of Aircraft

Testing System of Characteristics of Electrical Vibration Table

Development Of Automatic Vibration Calibration System

Study and Establishment of the National Standard of the Ultra-low frequency Vibration

Design and Application of Ultra-low Frequency Vibration Laboratory

Development and Application of Steam Turbine Vibration Sensor Fault Diagnosis and Calibration Instrument

Development of Portable Ultrasonic Non-Destructive Test System for Viod Content of Carbon-Fiber Reinforced Plastics

An Automatic Test System for a Spaceborne Chip of a Temperature-Sensing Controller

Application of the Quartz-flexure Accelerometer to the Development of Ultra-low Frequency Vibration National Primary Standard Device

MEMS Acceleration Sensor Vibration Detection System with LoRa Communication

On-line Testing System for Fatigue Spectrum Load of Structure Materials

Design of vibration test system for CNC milling machine

Design and Implementation of Testing Device for Damping Oil Bulk Modulus and Fatigue Characteristic

Research on the virtual instrument-based integrated test system for aircraft electrical power system

The design of vibration testing system based on lab VIEW for wind turbine

Design and validation of a fast wireless low-frequency vibration inspection system for offshore platform structures

Dynamic Properties of the Aircraft’s Full-scale Component Test Setup and its Vibration-based System of Structural Health Assessment

Design of Low-frequency Vibration Detection System

Satellite Vibration Environment Test:Acceleration Control and Over-test

Design and development of ultra-low-power MEMS lead-free piezoelectric accelerometer digital system for unmanned aerial vehicle motor monitoring

Industrial application of a low-cost structural health monitoring system in large-scale airframe tests