Abstract:Low compression end temperatures, high heat loss, and large resistance torque cause difficulty in starting con-ventional diesel engines at extremely low temperatures. The diesel-electric hybrid is equipped with high-capacity battery, which can support high-energy-consuming preheating measures to improve low-temperature cold-start performance. However, only a few studies have been conducted on the effect of preheating on the low-temperature cold-start performance of diesel-electric hybrid. In this study, the influence of different preheat-ing temperatures on the performance, emissions, energy consumption, and conversion of a diesel-electric hybrid was experimentally investigated by designing an environmental simulation system and a preheating system. The results showed that intake air preheating consumed less energy and maintained a high energy conversion effi-ciency. As the intake air temperature increased, the combustion conditions improved, increasing the indicated mean effective pressure and enhancing combustion stability. However, intake preheating was invalid when the ambient temperature was below 244 K because of the high heat loss and large resistance torque. As the coolant temperature increased, the ignition delay period was significantly reduced, allowing the maximum pressure in the cylinder to increase. The corresponding position became closer to the top dead center, resulting in a steady increase in the speed rise rate, a reduction in hydrocarbon emissions from 1403 ppm to 298 ppm, and a reduction in opacity from 85% to 43%. The increase in the lubrication temperature mainly decreased the resistance torque, resulting in a reduction in the drag time and rise time of 0.37 s and 2.21 s, respectively. At 233 K, the minimum energy consumption of the combined preheating of the coolant and intake air was 2557 kJ. In contrast, the combined preheating of the lubricant and intake air was only 379 kJ, but the emission performance of coolant preheating was better than that of lubricant preheating. This result could be considered as the constraint boundary for optimizing the total equivalent energy consumption and is useful for optimizing the preheating strategy and development of diesel-electric-hybrid low-temperature thermal management.

Application of Heat Material and Elements of Self-limiting Temperature in Cold Starting for Diesel Vehicle

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

Experimental Investigation of the Effects of Preheating Temperature on Low-Temperature Cold Start Performance, Emissions and Energy Conversion of Diesel-Electric Hybrid

Study of Diesel Fuel Heating by Intelligent Materials under Transient High Pressure

Heating Strategy for Electric Vehicular Battery Pack Based on CFD Analysis

An Experimental Study on the Measures for Improving Cold Start/Warm-up Process of Engine

Reducing Cold Start Emissions from Automotive Diesel Engine at Cold Ambient Temperatures

Experimental Study on Improving Cold Start Performance of Diesel Engines at Extremely Low Ambient Temperatures with Diethyl Ether

Impacts of different ambient temperatures on cold-start characteristics of speed-up duration of an ISAD hybrid diesel engine in plateau

Cold Start Performance of Diesel Engine at Extremely Low Ambient Temperatures and High Altitudes: the Superiority of Premixing Diethyl Ether

Experimental Study on Reducing Exhaust Emission During Cold-Start Period of Gasoline Engine Using a Heater

Simulation of diesel fuel heating under transient high pressure

Cold and Warm Start Characteristics using HVO and RME Blends in a V6 Diesel Engine

Improving Cold Start and Transient Performance of Automotive Diesel Engine at Low Ambient Temperatures

Intake Air Heating Strategy to Reduce Cold-Start Emissions from Diesel Engines

Development of the design of an internal combustion engine cooling system with a pre-starting heating function

The Optical Investigation on Initial Flame Developing Characteristics of Diesel Jet under Cold Start Conditions

On the emission reduction through the application of an electrically heated catalyst to a diesel vehicle

Numerical analyses of non-isothermal self-start behaviors of PEM fuel cells from subfreezing startup temperatures

Numerical studies of cold-start phenomenon in PEM fuel cells

Thermal Management Opportunity on Lubricant Oil to Reduce Fuel Consumption and Emissions of a Light-Duty Diesel Engine