Abstract:The effects of internal pressure on forming defects, corner radius and thickness distribution of 5A02 aluminum alloy shear hydro-bending tubes were studied by experiment. Numerical simulation was conducted to analyze the effect of internal pressure on axial strain and invariable lines of thickness strain. The ultra-small bending tubes were successfully manufactured when the relative internal pressure, ratio of internal pressure and yield stress of the material, is higher than 0.2. The relative bending radius of the first outer corner decreases from 0.3 to 0.025 when the relative internal pressure increases from 0.2 to 1.2. The axial thickness distribution is different in intrados and extrados. The changing rate of thickness is larger with a higher internal pressure. The minimum thickness decreases from 1.45 mm to 0.87 mm when the relative internal pressure changes from 0.2 to 1.2. The tube is divided into feeding zone, the first corner, shearing zone, the second corner and holding zone. The strain of feeding zone and the first corner is compressive caused by the feeding. The strain of the second corner and holding zone is tensile for far away from feeding punches. The strain of shearing zone changes from compressive to tensile with rising of internal pressure. On one hand, the smaller corner radius formed by higher internal pressure blocks the feeding. On the other hand, the corner filling strengthens the extensive strain of shearing zone. In the feeding zone and holding zone, thickness strain is positive, and the tube thickens. In the corner and shear zones, thickness strain is negative, and the tube thins.

Numerical Simulation of the Internal Pressure Bending Process of Small Bend Radius Aluminum Alloy Tubular Parts

Numerical Simulation and Buckling Analysis of Tube External Pressure Forming

Influence of Internal Pressure on Hydro-Bending of Thin-Walled Aluminum Alloy Tube

Numerical Simulation and Experimental of Forming Defects in Roll-Bending Process for Z-Shaped Profiles With Large Cross-Section

Finite element simulation of stretch bending on aluminum alloy extrusions

Thin-Walled Aluminum Alloy Tube Nc Precision Bending Based on Finite Element Simulation

Numerical Simulation on Optimization of Process Parameters for Free Bending of Metal Tubes

Numerical and experimental study on in-plane bending of microchannel aluminum flat tube

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Numerical Simulation and Experiment of Aluminum Sheet Metal Springback in New Quenching State

Effect of Internal Pressure on Corner Radius and Thickness Distribution of Shear Hydro-Bending of 5a02 Aluminum Alloy Tube

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

Computer Simulation for Combining of Irregular Tube Bending and Internal High Pressure Forming Process

Deformation Behavior of Thin-Walled Tube Bending with Internal Pressure

Three-dimensional Finite-Elements Modeling and Simulation of Rotary-Draw Bending Process for Thin-Walled Rectangular Tube

Forming Characteristics of Thin-Walled Tube Bending Process with Small Bending Radius

Effect of Internal Pressure on Thin-Walled Tubes Bending with Internal Pressure

Finite element simulation of 3D bending process of tube

Numerical Simulation on Influence of Clearance and Friction on Wrinkling in Bending of Aluminum Alloy Rectangular Tubes

A Study of Axial Force and Bending Moment in Tube Numerical Control Bending Based on Finite Element Method

Numerical simulation of influence of mandrel on wrinkling in bending of thin-walled rectangular tube