SIMULTANEOUSLY IN-SITU TOUGHENING AND LOW SHRINKING OF UNSATURATED POLYESTER RESIN

杨睿,潘安徽,赵世琦

DOI: https://doi.org/10.3321/j.issn:1000-7555.2003.04.037

2003-01-01

Abstract:Unsaturated Polyester Resin (UPR), as an important kind of thermoset resins, is widely used. But its application was limited by two major defects: big shrinkage and brittleness after cured. In this paper, three kinds of additives(QS-M, QS-E, QS-MB) were developed to serve as both tougheners and low shrinkage additives. From mechanical properties and heat property, such as fracture toughness, notched impact strengh, tensile modulus, heat distortion temperature, it can be found that all these additives have good effects on toughening and lowering shrinkage, among them, QS-MB is the best. Furthermore, as compared QS-MB with a commercial low profile agent H-870, the result shows that QS-MB is a very good toughener and low shrinkage additive, while H-870 has little effect on toughness but UPR with it has smaller shrinkage.