Distributed Real-Time Control System Used for Five-Axis Simulator
Kangkang AN,Jinxin HUANG,Hong HU
DOI: https://doi.org/10.16086/j.cnki.issn1000-0380.201703007
2017-01-01
Abstract:Traditional control systems transfer analog and digital signals to the power amplifier or other components via the computer,however they are bulky,and their structure is complex,the failure rate is high and these failures are difficult to be located.In order to achieve the real-time control for the simulator of five degrees of freedom (five-axis) coarse sun sensor physical signal source and simplify the system structure,the novel distributed real-time control system based on CAN fieldbus and using CanOpen protocol is researched.In this system,all the controls are distributed into computer,the fieldbus controller,servo drivers,digital I/O,and sensors,etc.,and the real-time data communication among all the components are connected via a network cable in cascade manmer;the failure of any node can be fast and accurately located and does not affect the normal operation of other nodes.The modular control system simplifies the design of the control system,reduces the number of cables and the space of the control system,minimizes the influence of the failures,and improves reliability and maintainability of the system.The flexibility and real-time performance of the system in motion trajectory are further verified by adopting the sinusoidal swing motion implemented by PVT.The control system promotes the development of the control structure in the industrial automation field,including stnucture simplification,real-time control performance and reliability,etc.