Abstract:Owing to the increase of difference between peak load and valley load of electrical network, many boiler must often operate at low load. Many power plants require that boiler can operate steadily at low load without support oil to improve the economy and the safety of power plant. To meet these requirements a stability combustion technology named rich/lean combustion of pulverized coal is developed by ITPE of Zhejiang University. The pulverized coal in primary air is separated into two streams of air-coal flow, one is the rich pulverized coal stream and other is the lean pulverized coal stream. The rich pulverized coal stream is guided to the high temperature area facing the flame which contributes to ignition and flame stability of pulverized coal. The lean pulverized coal stream is guided to low temperature area located behind the flame and forms a air film near furnace wall that benefits to reduce the slagging on the wall. The combustion technology is used far the low load flame stabilization of pulverized coal without support oil and prevention of furnace wall slagging and low NOX emission.In this paper, a large gas-solid phase flow test facility was built to test separate efficiency of a specially designed guiding-separate equipment. The maximal air flow of the test rig can reach 6000 m(3)/h and particles flux is up to 3-4 t/h. The experimental result of the new developed guiding separate equipment is introduced. Base on the test data the mechanisms of coal combustion flame stability and resistant-slagging are discussed. It shows that the ratio of the concentration of the rich side to lean side is up to 7-12:1. The pressure difference of the guiding equipment is about 300-400Pa.The study has been done on retrofitting the tangentially coal-fired boiler, which total steam capacity is 65 t/h and the coal type used is bituminous coal, in No4 Power Plant of Qiqihar Paper Mill by using the stability combustion technology. The industrial test shows that the lowest load without support oil is about 45%, the pulverized coal in the furnace combusts steady. No slagging was found on the wall of the boiler retrofitted. The boiler efficiency of the boiler to burn bituminous coal is improved apparently after the retrofit, which boiler efficiency increases from 82% to 88%. It can save about 500 ton/year support oil.

Development of Concentrated Pulverized Coal Burnerand Multi-concentrated Pulverized Coal Burner

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

Experimental Study on the Performance of Concentrated-thin Swirling Pulverized Coal Burner with Low Load

EXPERIMENTAL STUDY OF EFFECT OF PULVERIZED COAL CONCENTRATION ON COAL IGNITION WITH HOT WALL

The Application Study Of Rich/Lean Stability Combustion Technology Of Pulverized Coal

Experimental research on the fire-carrying problems in primary air nozzle of 125 MW units

Establishment of Combustion Stability Index of Pulverized-Coal

CFD Modeling and Industry Application of a Self-Preheating Pulverized Coal Burner of High Coal Concentration and Enhanced Combustion Stability under Ultra-Low Load

High-Temperature Oxygen-Enriched Oil-Free Pulverized Coal Ignition

The use of coflowing jets with large velocity differences for the stabilization of low grade coal flames

Combining Fuel Rich/Lean Burner with the Small Heavy Oil Gun Ignition Techniques Makes Pulverized Coal-Fired Boiler More Efficient

The Application of a Combustion System of Pulverized Coal Concentration and Preheating Regulation on a 150 T/h Pulverized Coal-fired Boiler

Review on research and development of oxy-coal burner for carbon capture

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

Analysis of Pulverized Coal Flame Stabilized in a 3D Laminar Counterflow

Experimental Study on High Temperature Air Multistage Ignition Combustor

EFFECTS OF CONCENTRATION DISTRIBUTION OF PULVERIZED COAL ON COMBUSTION

Principle and Experimental Study of Oxygen-Enriched High Temperature Air Combustion Burner

TEST STUDY ON RELATIONSHIP BETWEEN PULVERIZED COAL CONCENTRATION AND IGNITING POINT IN OILLESS IGNITION BURNER

Experiment and Numerical Simulation on High-Temperature Oxygen-Enriched Oil-Free Pulverized Coal Ignition

TEST AND STUDY ON DEVELOPING COMPOSITE BURNERS WITH CAPABILITY OF STABLE COMBUSTION UNDER LOW LOAD AND SLAGGING PREVENTION UNDER HIGH LOAD