Abstract:A new linear yield criterion in terms of principal stresses is developed for the purpose of overcoming the analytical difficulty of mechanical parameters when using the nonlinear Mises yield criterion. This developed yield criterion is established through the parabola interpolation method and the mathematical averaging method, which can be called as the mean influence factor yield criterion, or called MIF yield criterion for short. The yield locus of the criterion on the (pi )-plane is an equilateral and non-equiangular dodecagon, lies between the Tresca and TSS loci, and is very close to the locus of the Mises yield criterion. By comparing with the classical yield criteria, the MIF yield criterion varies linearly with the Lode parameter and has a good accuracy with experimental data. Moreover, based on the flow rule and the geometric projection of the principle stress components, the specific plastic work rate of the yield criterion is also derived. The criterion and its specific plastic work rate are used to solve the limit load of a simply supported circular plate and the forging of a rectangular bar, and both the corresponding analytical solutions are obtained. The theoretical results for the limit load and the forging force are in good agreement with the simulation and experimental data, respectively, and are more accurate than the results calculated from other yield criteria.

UNIFIELD PLASTIC LIMIT ANALYSIS OF METAL CIRCULAR PLATES SUBJECTED TO BORDER UNIFORMLY DISTRIBUTED LOADING

UNIFIED PLASTIC LIMIT ANALYSES OF CIRCULAR PLATES UNDER UNIFORM ANNULAR LOAD

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Unified Plastic Limit of Clamped Circular Plate with StrengthDifferential Effect in Tension and Compression

UNIFIED SOLUTIONS FOR PLASTIC LIMIT OF ANNULAR PLATE

UNIFIED LIMIT SOLUTION FOR OBLIQUE PLATES OF METAL

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

THE UNIFIED SOLUTION FOR AN ELASTO-VISCOPLASTIC PROBLEM

Unified Characteristics Line Theory of Spacial Axisymmetric Plastic Problem

Unified Solution of a Borehole Problem with Size Effect

Three-dimensional solution of axisymmetric bending of functionally graded circular plates

Load-carrying capacity of welded hollow spherical joints subject to combined planar tri-directional axial force and bending moment

Upper-bound Limit Analysis Method of Thin Plates Based on the Nonconforming Rectangular Bending Element

Solutions of some plastic plain strain problems based on unified strength theory and unified slip line field theory

The Unified Limit Load Solution of Fiber-reinforced Concrete Cylinders Considering the Strain Softening of Material

Upper Bound Limit Analysis of Plates Utilizing the C1 Natural Element Method

Numerical Simulation Analysis on Buckling Load of Large Combined Cylindrical Shells

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Proposal and application of a new yield criterion for metal plastic deformation

Analytical solutions for limit loads of simply supported conical shells under internal pressure with unified yield criterion