Effects of Cone Angle on Gas-Solid Two-phase Flow in the Swirl Burner

Yu YANG,Weichen MA,Kang DONG,Hao ZHOU
DOI: https://doi.org/10.3969/j.issn.1674-7607.2015.11.003
2015-01-01
Abstract:Phase Doppler Anemometry(PDA)was used to measure the flow field around the exit of a low NOxswirl burner,during which both the gas/solid velocity and the solid concentration distribution were obtained.Results show that the maximum radial span of the recirculation zone would rise from 40 mm to70mm,and the maximum velocity of backflow would rise from 1.97m/s to 2.45m/s,when the cone angle of swirl burner is raised from 30°to 45°.The enlargement of recirculation zone helps to delay the mixing of secondary air with primary air,which is beneficial to the reduction of NOxemission.When the cone angle increases to 60°,the secondary air would flow along the wall,and a big low-velocity recirculation zone would occur in the area between primary and secondary air,which is unable to entrain enough hightemperature flue gas to heat the primary air,thus resulting in abnormal combustion of the burner.
What problem does this paper attempt to address?