Abstract:Background: This study aimed to determine the acetabular position to optimize hip biomechanics after transposition osteotomy of the acetabulum (TOA), a specific form of periacetabular osteotomy, in patients with hip dysplasia. Methods: We created patient-specific finite-element models of 46 patients with hip dysplasia to simulate 12 virtual TOA scenarios: lateral rotation to achieve a lateral center-edge angle (LCEA) of 30°, 35°, and 40° combined with anterior rotation of 0°, 5°, 10°, and 15°. Joint contact pressure (CP) on the acetabular cartilage during a single-leg stance and simulated hip range of motion without osseous impingement were calculated. The optimal acetabular position was defined as satisfying both normal joint CP and the required range of motion for activities of daily living. Multivariable logistic regression analysis was used to identify preoperative morphological predictors of osseous impingement after virtual TOA with adequate acetabular correction. Results: The prevalence of hips in the optimal position was highest (65.2%) at an LCEA of 30°, regardless of the amount of anterior rotation. While the acetabular position minimizing peak CP varied among patients, approximately 80% exhibited normalized peak CP at an LCEA of 30° and 35° with 15° of anterior rotation, which were the 2 most favorable configurations among the 12 simulated scenarios. In this context, the preoperative head-neck offset ratio (HNOR) at the 1:30 clock position (p = 0.018) was an independent predictor of postoperative osseous impingement within the required range of motion. Specifically, an HNOR of <0.14 at the 1:30 clock position predicted limitation of required range of motion after virtual TOA (sensitivity, 57%; specificity, 81%; and area under the receiver operating characteristic curve, 0.70). Conclusions: Acetabular reorientation to an LCEA of between 30° and 35° with an additional 15° of anterior rotation may serve as a biomechanics-based target zone for surgeons performing TOA in most patients with hip dysplasia. However, patients with a reduced HNOR at the 1:30 clock position may experience limited range of motion in activities of daily living postoperatively. Clinical relevance: This study provides a biomechanics-based target for refining acetabular reorientation strategies during TOA while considering morphological factors that may limit the required range of motion.

Treatment of Developmental Dysplastic Hip with Early Stage of Osteoarthrosis by Transpositional Acetabulum Osteotomy

The Treatment of the Fibrous Dysplasia of the Proximal Femur with Coxa Vara by Osteotomy Plus Plate Fixation

Rotational acetabular osteotomy for early-mid-stage osteoarthritis secondary to acetabular dysplasia

Clinical Application of Total Hip Arthroplasty with a Short-Neck and Straight Stem for Treatment of Developmental Dysplastic Hip with High Dislocation

A Computer Modeling-Based Target Zone for Transposition Osteotomy of the Acetabulum in Patients with Hip Dysplasia

Evaluation of Tagawa's Rotational Acetabular Osteotomy for the Treatment of Congenital Acetabular Dysplasia

Treatment of bilateral developmental dysplasia of the hip joint with an improved technique: A case report

Total Hip Arthroplasty with Cementless Cups and Femoral Head Autografts for Patients with Hip Dysplasia and Osteoarthritis

Total Hip Arthroplasty for the Treatment of End-stage Acetabular Dysplasia

[Total Hip Arthroplasty with Uncemented Cup and Femoral Head Autografts for Coxarthrosis Due to Dysplasia].

Factors associated with joint survival after transposition osteotomy of the acetabulum in patients with Tönnis grade 2 osteoarthritis secondary to hip dysplasia

Surgical treatment for developmental dysplasia of hip in older children

[Total Hip Arthroplasty for Crowe Type IV Developmental Dysplasia of the Hip with S-ROM Prosthesis].

Low osteotomy cut of Dega procedure for older children with developmental dysplasia of the hip

Comparison of Two Surgical Approaches for Periacetabular Osteotomy: A Retrospective Study of Patients with Developmental Dysplasia of the Hip

Rotational Acetabular Osteotomy for Secondary Osteoarthritis after Surgery for Developmental Dysplasia of the Hip

Comparison of open reduction alone and open reduction plus Dega osteotomy in developmental dysplasia of the hip

Total hip arthroplasty after rotational acetabular osteotomy for developmental dysplasia of the hip: a retrospective observational study

Rotational acetabular osteotomy for advanced osteoarthritis secondary to developmental dysplasia of the hip

Clinical evaluation of direct anterior approach total hip arthroplasty for severe developmental dysplasia of the hip

Medium- to long-term clinical efficacy of total hip arthroplasty with structural bone grafting for dysplasia of the hip