CONTACT PRE-TIGHTENING EFFECT OF NONLINEAR ELASTIC MATERIAL ON A CYLINDRICAL STRUCTURE OF MULTI-LAYERS

牛莉莎,郁向东,郭然,陈裕泽,施惠基

DOI: https://doi.org/10.3321/j.issn:1001-9669.2002.01.036

2002-01-01

Abstract:Using a nonlinear and elastic material to pre tighten a multi layer cylindrical structure concerns the effects of the geometrical and material non linearity and also the friction between the contact surfaces. When the hardness of the materials in the structure is very different, the low hardness material presents high deformation and increases the level of the geometrical non linearity. The level and distribution of the pre stresses are influenced by the general and local stiffness of the structure, the contact area and the press degree. In this paper, a mechanical test and a numerical simulation are carried out on a cylindrical structure of two layer metals pressurized by rubber. Then, this structure is subjected to a concentrative load situated at the center and the behavior of the rubber layer is obtained under the complete stress condition. In the numerical modeling, the direct contact model and the friction model of Coulomb are used. Using two half ring to press the rubber layer and finally fix the structure is the same process in both experiment and numerical simulation. The results of the simulation agree with the experimental data. It seems that the numerical model is valid to simulate the contact pressurized structure with nonlinear and high deformation.