Abstract:Scaling the areal density, while maintaining a proper balance between media signal-to-noise, thermal stability and writability will soon require an alternative recording technology. Heat Assisted Magnetic Recording (HAMR) can achieve this balance by allowing high anisotropy media to be written by heating the media during the writing process (e.g. by laser light) to temporarily lower the anisotropy. Three major challenges of designing a HAMR head that tightly focuses light and collocates it with the magnetic field are discussed: 1) Magnetic Field Delivery, 2)Optical Delivery, and 3) Integration of Magnetic & Optical Field Delivery Components. Thousands of these HAMR heads were built into sliders and HGAs, and optical and scanning electron micrograph images are shown. Scanning near-field optical microscopy (SNOM) characterization of the HAMR head shows that the predicted ~λ/4 full-width half-maximum (FWHM) spot size can be achieved using 488 nm light (124 nm was achieved). SNOM images also show that wafer level fabricated apertures were able to effectively eliminate sidelobes from the focused spot intensity profile. An MFM image of HAMR media shows that Non-HAMR (laser power off) was not able to write transitions in the HAMR specific media even at very high write currents, but transitions could be written using HAMR (laser power on), even at lower write currents. A cross-track profile is shown for a fully integrated HAMR head where the magnetic pole physical width is ~350 nm, but the written track is ~200nm, which demonstrates HAMR. A HAMR optimization contour shows that there is an optimum write current and laser power and that simply going to the highest write current and laser power does not lead to the best recording. Lastly, some prospects for advancing HAMR are given and a few key problems to be solved are mentioned.

New Progress on Laser- Assisted Recording- Hybrid Recording

Recent Progresses in Recording Mediums of Optical Storage

Heat Assisted Magnetic Recording with A Fully Integrated Recording Head

Heat-assisted Magnetic Recording by a Near-Field Transducer with Efficient Optical Energy Transfer

Photochromic digital data storage technology

Multilevel Optical Data Recording Methods on Phase-Change Media

Heat Assisted Magnetic Recording with Matching Media and Recording Head Field

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

High performance photopolymer recording materials for holographic storage

Near-field optical recording and its recent progress

New Way to Improve the Reliability of High-Speed and Mass Data Recording Optical Disk Array

Multi-wavelength and Multi-Level Optical Storage Based on Photochromic Materials

Areal density optimizations for heat-assisted-magnetic recording of high density bit-patterned media

High Density Collinear Holographic Data Storage System (conference Presentation)

Heat-Assisted Magnetic Recording’s Extensibility to High Linear and Areal Density

Progress in Optical Near-field Recording and Materials

Enhancement of Recording and Readout for the Photopolymer Holographic Disk System by Using a Conjugate Structure

Blue-laser Optical Recording and Its Extended Technology

Below-Diffraction-Limited Hybrid Recording Using Silicon Thin Film Super-Resolution Structure

From Perpendicular Magnetic Recording to Heat Assisted Magnetic Recording

Super-Resolution Near-Field Structure and Its Research Progress of Recording and Readout Mechanisms