Abstract:The current research for the vehicle stability regions mainly focuses on the two-dimensional plane domain of yaw rate and sideslip angle, without considering the influence of body roll angle on vehicle stability performance. To improve the vehicle stability, in this study, based on the study of the spatial distribution of the unstable state, a method of determining the three-dimensional stability region of “lateral speed–yaw rate–roll angle” was proposed, the variation of the stability region with front steering angle was studied, and the limit steering angle boundary of several typical road conditions was obtained. Secondly, the minimum distance between the vehicle state point and the stability region was used to measure the vehicle stability, and the stable roll angle range and ideal roll angle under different speed and front steering angles were obtained. Finally, on high and low adhesion roads, the simulation comparisons of the vehicle stability under the ideal state trajectory and the two controllers were carried out. The results demonstrated that the higher the vehicle speed, the lower the road adhesion coefficient, which meant that the vehicle driving condition was worse; the trend of ideal roll angle moving against the original roll direction was more intense. At low speed, although the vehicle stability considering the ideal roll angle was improved, the stability without considering the roll angle could still meet the safety requirements. However, at high speed, the vehicle stability considering the ideal roll angle was significantly improved; especially when the vehicle was driving at high speed on a low adhesion road, the mean and minimum of the stability performance index corresponding to the ideal roll angle were increased by 23.89 and 50.16%, respectively.

Analyzing and Improving Roll Stability of An Off-road Vehicle Based on ADAMS

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

Research on roll stability of articulated engineering vehicles based on dynamic lateral transfer load

The Study For Anti-Rollover Performance Based On Fishhook And J Turn Simulation

Roll Stability Model of Lateral Load Transfer of Passenger Vehicle

Sensitivity Analyses of Motor Car Suspension Parameters' Impacts on Vehicle Performance Based on ADAMS

Study on Rollover Risk Factors of Vehicles Based on ADAMS/Car

Modeling and Dynamic Character Analyzing of Twist Beam Rear Suspension on ADAMS

Synthetic Optimization of Trafficability and Roll Stability for Off-Road Vehicles Based on Wheel-Hub Drive Motors and Semi-Active Suspension

A Method of Three-Dimensional Stability Region and Ideal Roll Angle to Improve Vehicle Stability

Simulation Research on Multi-Axle Vehicle Handing and Stability Performance

A STUDY ON IMPROVING THE CONTROL STABILITY OF COMMERCIAL VEHICLE

Modeling and simulation of all-terrain vehicle handling stability

Research Of An Anti-Roll Suspension Systems For Off-Road Vehicles

Investigation into Improvement for Anti-Rollover Propensity of Suv

Simulation and Analysis of Brake Judder Phenomenon by Using ADAMS

Modeling and analysis of vehicle stability region based on Lyapunov and coordinated control

Tip-Over Stability Analysis of Orchard Vehicle with Dynamic Simulation Method

Study on the Influence of Vehicle Structural Parameters on Vehicle Handling Stability

Consider Roll of Heavy Vehicle's Modeling Research

Investigation into Fuzzy PID Active Suspension to Improve Heavy Truck Roll Stability