Water Drag of Japanese Flounder Paralichthys Olivaceus

李文涛,张秀梅,高天翔,井爱国

DOI: https://doi.org/10.3321/j.issn:1005-8737.2004.03.010

2004-01-01

Journal of Fishery Sciences of China

Abstract:The hydrodynamic forces encountered by aquatic animals are of general interest in understanding the functional design of them and also affect their energetic requirements and therefore their body morphology and swimming patterns. They are also significantly ecological because they can affect aquatic animals' distribution, behavior or dispersal. The hydrodynamic drag forces act on the fish body when fish is swimming. Body size and morphology of fish vary among different individuals and species, so the drag forces acting on their bodies differ even in the same hydrodynamic conditions or swimming velocities. A recirculating water flume was used to generate steady flow relative to the fish specimen and the water drag acting on it. Using the principle of a bell crank lever, we designed a drag force transducer. The drag force transducer changed the horizontal drag into a vertical one and the vertical force was displayed on an electronic scale, a component of the drag force transducer. The drag force acting on fish specimen was calculated by summing the moments about the pivot point of the bell crank lever. Ten Japanese flounder(Paralichthys olivaceus) were experimented in a recirculating water flume. The drag forces acting on each fish specimen were measured at fifteen velocities(0.30, 0.35, 0.40, 0.45, 0.50, 0.55, 0.60, 0.65, 0.70, 0.75, 0.80, 0.85, 0.90, 0.95, 1.0 m/s)with the self-designed drag force transducer and then the drag coefficient could be calculated for each individual at each velocity. The drag coefficient calculated from measured drag data depends on how A is defined. In this case, we employed the cross-sectional area, the wetted surface area and the two-thirds powers of volume as the reference area. From the measured data we obtained three kinds of drag coefficients C_(df)(referenced to the cross-sectional area), C_(ds)(referenced to the wetted surface area)and C_(dv)(referenced to the two-thirds powers of volume). For the three kinds of drag coefficients the mean values were 0.70 for C_(df), (0.020) for C_(df) and 0.31 for C_(dv), with standard deviations of 0.094, 0.000 76 and 0.028, respectively (with the Reynolds number ranging from 2.7×10~4 to 1.91×10~5). The results showed that each drag coefficient referenced to different representative areas was distinct from the other two. Among the three kinds of drag coefficients, the standard deviation of the drag coefficient referenced to the wetted surface area is the least. So using wetted surface area to reckon water drag on Japanese halibuts is more suitable than other two kinds of drag coefficient.